| [ Total Views: 677 | Total Replies: 3 | Thread Id: 71417 ] |
|
|
 pete wood
A.k.a.: figure itout
23 Windows of Awesome
Posts: 6828
Threads: 389
Registered: January 15th, 2004
Member Is Offline
Location: Nth Nth StMarys, Sydney
Theme: UltimaBB Pro White
Mood: upgrades = jackstands
|
| posted on August 29th, 2008 at 09:16 PM |
|
|
cleaning up some oil leaks?
well it's one step forward two steps back. sump back on but oil all over the place. I need some tips to get it off two more delicate parts.
remembering this is a subaru EJ quad cam motor.
1. a few drops on the timing belt (rubber) and one pulley.
2. a bit more in the mass air flow sensor (don't ask how).
what should I clean it off with. I've already go most of it out of the maf sensor with some degreaser. pls tell me I haven't done the wrong thing?!
|
|
|
ian.mezz
Wolfsburg Elder
I never said, I could write or spell
Posts: 3913
Threads: 280
Registered: September 11th, 2004
Member Is Offline
Location: Newcastle
Theme: UltimaBB Pro Blue ( Default )
Mood: Happy
|
| posted on August 29th, 2008 at 10:42 PM |
|
|
brake cleaner
aerostart
|
|
|
Baja Wes
Bishop of Volkswagenism
V6 Baja Pioneer
Posts: 3119
Threads: 94
Registered: August 26th, 2002
Member Is Offline
Location: Brisbane
Theme: UltimaBB Pro Blue ( Default )
Mood: Content
|
| posted on August 29th, 2008 at 10:44 PM |
|
|
For the air flow sensor you should use isopropyl alcohol (did I get that right?). It is good for electrical stuff because it evaporates completely and
doesn't leave any residue. Degreasers might be a bit agressive, they tend to eat some light metals (depending on the exact degreaser). WD40 leaves a
kero like residue.
|
|
|
ElusiveStranger
Officially Full-On Dubber
Posts: 330
Threads: 30
Registered: May 28th, 2006
Member Is Offline
Location: Kent. England
Theme: UltimaBB Pro Blue ( Default )
|
| posted on August 30th, 2008 at 10:02 AM |
|
|
WHS^^^
Isopropyl alcohol or IPA is the best for degreasing, use a cotton wool bud, bud 
Meths (methylated spirit) would make a good second choice for oil on the MAF.
Trichlorethylene - (maybe brake/carb cleaner in Oz - check) is good too. Now hard to get hold of)
A lot of 'degreasers' contain an oil to stop corrosion. Do not use.
A very good, cheap degreaser is Acetone - beware it can destroy plastics! Nail polish remover might be suitable but most contain moisturisers, a bad
thing(TM). If you use a plastic stemed cotton wool bud it will melt the stem.
HTH
|
|
|
