| [ Total Views: 1226 | Total Replies: 4 | Thread Id: 84333 ] |
|
|
 liam66
Officially Full-On Dubber
Posts: 260
Threads: 90
Registered: October 17th, 2005
Member Is Offline
Location: Sydney
Theme: UltimaBB Pro Blue ( Default )
|
| posted on June 17th, 2010 at 11:58 AM |
|
|
ej20t oil cooler
On an ej20t theres a water cooler/heater doodad above the standard filter location...can it be removed and left off.?.. I'm remote mounting the oil
filter but still chasing some more clearance.
|
|
|
1303Steve
A.k.a.: Steve Carter
Scirocco Rare
Posts: 8636
Threads: 559
Registered: August 27th, 2002
Member Is Offline
Location: Sydney, NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Parrot Heading
|
| posted on June 17th, 2010 at 02:03 PM |
|
|
Hi
I took the one out of my old WBX motor, all I had to do was unscrew the centre bit and screw in a short one from a model that didn't use the oil
cooler.
Steve
|
|
|
STIDUB
Custom Title Time!
Over it.
Posts: 1497
Threads: 57
Registered: June 23rd, 2008
Member Is Offline
Location: Where else but QLD :)
Theme: UltimaBB Pro Blue
Mood: Worn out, for no benefit.
|
| posted on June 17th, 2010 at 06:21 PM |
|
|
looks like it from what ive looked at on mine, havent tested the theory though, see who finds out first?
Volkswagen Drivers Club of Queensland - member 
STIDUB - yep its still a work in progress
Vwdcq club car racing/ and crashing while my bug isn't finished.
The above are personal views, no more, no less |
|
|
ratbug
A.k.a.: Andrew Todd
Wolfsburg Wizard
aka toddy101
Posts: 439
Threads: 30
Registered: January 14th, 2003
Member Is Offline
Location: Newcastle
Theme: UltimaBB Pro Blue ( Default )
|
| posted on June 17th, 2010 at 08:07 PM |
|
|
I took mine off (for offroad clearance), i gathered unless i do high rpm trackwork i shouldn't really need it, also have cooling fins on the sump.
All you need to do is get a plug off an engine that doesnt have the oil cooler and replace the coolant pipe nipple, as the blocks are the same. The
plug is for the coolant and its the one right next to the cooler. You then just need to buy a 1/2" (i think) coolant block off piece (pickup from
auto stores) to block the port on the water pump that runs to the pipe across the front of the sump to the cooler. Easy as!
|
|
|
ratbug
A.k.a.: Andrew Todd
Wolfsburg Wizard
aka toddy101
Posts: 439
Threads: 30
Registered: January 14th, 2003
Member Is Offline
Location: Newcastle
Theme: UltimaBB Pro Blue ( Default )
|
| posted on June 17th, 2010 at 08:15 PM |
|
|
Found a photo, here is part of the block you need to blank off with a screw in plug, on the very right hand side of the photo.
And here it is, you can just see where the plug goes behind the oil filter slightly hidden by the timing cover bolt.
|
|
|
