Subject: Weighted pulley with Flexplate on autostick beetle
68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline
Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -
posted on July 16th, 2011 at 09:02 PM
Weighted pulley with Flexplate on autostick beetle
What do You think of a Weighted pulley on a standard crankshaft on a 1600 single port engine with single throat weber
extractors and a Bosch SVDA distributor..
on an Autostick semi auto beetle that has NO Flywheel....
just a Flexplate connected to the Torque Converter ????
Lee
- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
matberry
Super Moderator
Go hard or go home
Posts: 8114
Threads: 134
Registered: March 7th, 2006
Member Is Offline
Location: Cooroy Qld
Theme: UltimaBB Pro Blue
Mood: enjoying waving at all my Kombi buddies from my T3
posted on July 16th, 2011 at 09:24 PM
Errr no Lee, I mean, spend the money on one if you want, best with a genuine Berg article though. (sarcasm font desired)
With the auto, the torque convertor is a large weight that can't be lightened so no real need....but you knew that hey ??
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline
Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -
posted on July 16th, 2011 at 11:37 PM
I knew You would back up My thoughts Mat...
lol
Lee
- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
posted on July 16th, 2011 at 09:02 PM
posted on July 16th, 2011 at 11:37 PM