Posts: 162
Threads: 43
Registered: December 22nd, 2009
Member Is Offline
Location: Toukley, Central Coast NSW
Theme: UltimaBB Pro Orange
Mood: Hangin' to drive my bug!
posted on January 11th, 2012 at 09:46 PM
EDIS VR sensor
Hi,
Anyone familiar with the gap for the EDIS VR sensor?
From what I've read it should be anything from 30 to 60 thou between the sensor and the trigger wheel. Try as I might I always seem to wind up with
it being more like 25 thou. Does anyone know what if any effect this will have? Or is 25 thou still ok?
Many thanks, Marc.
Baja
1915cc's of raw power
Turbocharger
Intercooler
EFI
Crank fired Ignition
Runs E85
Engineered
"The Lord does not subtract from the life of a man, the hours spent on his Volkswagen" Anon.
Imac
Commited Dubber
Posts: 67
Threads: 0
Registered: December 13th, 2009
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on January 12th, 2012 at 06:39 AM
Should be OK but if your concerned start the engine and file a few thou off the trigger wheel.
Cheers Ian
beachbuggy61
Seriously Crusin Dubber
Posts: 162
Threads: 43
Registered: December 22nd, 2009
Member Is Offline
Location: Toukley, Central Coast NSW
Theme: UltimaBB Pro Orange
Mood: Hangin' to drive my bug!
posted on January 12th, 2012 at 02:09 PM
Thanks Ian, Geez that's a bit of a rough technique! I haven't got any touching, so I think I'll just leave it as it is.
I had to get it remounted. I was getting some touching and found it was off centre by 8 thou, so had it reset and now it's fine.
All I have to do now is get the megasquirt tuned properly and we're all go!
Cheers,Marc.
Baja
1915cc's of raw power
Turbocharger
Intercooler
EFI
Crank fired Ignition
Runs E85
Engineered
"The Lord does not subtract from the life of a man, the hours spent on his Volkswagen" Anon.
