Board Logo
Go To Bottom

Printable Version  
[ Total Views: 866 | Total Replies: 4 | Thread Id: 98660 ]
Author: Subject:  Transaxle ratios
Memberbeetleboyjeff
A.k.a.: Jeff Walsh
Custom Title Time!
*****


Avatar


Posts: 1773
Threads: 40
Registered: February 13th, 2009
Member Is Offline

Location: Port Macquarie
Theme: UltimaBB Pro Blue ( Default )
Mood: Drive bugs hard

posted on September 3rd, 2012 at 12:03 AM
Transaxle ratios


The transaxle in my 75 L bug has been losing reverse (again) for quite a while now (backing trailers too often), and it finally got too bad, so I swapped it with a $100 'mystery' trans. that I bought from Lithgow a few years ago.

My L bug trans. is single side plate, and the trans. I have replaced it with is a double side plate. I also had to change the nose cone as the one on it was 2 holes for the mount, and mine is 3 holes for the mount.

I then found that the holes for the rear mounts had metal 'plugs' in them - I think I saw them in a thread some time ago, and I think it means it is a type 111 trans.

The question is, does anyone have any idea of that the difference in the ratios and/or diff may be between the 2 transaxles?

It is only temporary untill I can afford to get Dangerous (I hope) to work magic on my 'good' transaxle (well, good except that it also has a shot reverse), but if I need to be carefull about engine speeds (mainly on the highway), I would like to be aware of it.




From your ole' mate Jeff
Membervwo60
Veteran Volks Folk
*****


Avatar


Posts: 2036
Threads: 71
Registered: February 13th, 2007
Member Is Offline

Location: Pomona Qld
Theme: UltimaBB Psyche Blue
Mood: good

posted on September 3rd, 2012 at 07:20 AM



You will need the code of the box, its stamped on the side at the front, then go the check it on this site. it will only tell you the diff ratio but with a bit of research you should be able to determin the rest of the ratios.
http://www.pre67vw.com/production/gearbox_codes.aspx 
SEDAN, bug, type 1
Rev. 1st 2nd 3rd 4th Ring & Pinion Overall in 4th
36 horsepower 4.63 3.60 1.88 1.22 0.79 4.375 3.45
'61-'65 3.88 3.80 2.06 1.32 0.89 4.375(g) 3.89
'66 (1300) 3.88 3.80 2.06 1.26 0.89 4.375 ? 3.89
'67-'72 (AH) (a) 3.88 3.80 2.06 1.26 0.89 4.125 3.67
'73-'77 (AT) 3.79 3.78 2.06 1.26(b) 0.93(b) 3.875 3.60
'71-'77 Ghia 3.875
'75+ Dealer Item, used in Brazil 1.36 1.04 4.62

VARIANT, fastback, squareback, notchback, type 111
Rev. 1st 2nd 3rd 4th Ring & Pinion Overall in 4th
'62-'64 3.88 3.80 2.06 1.32 0.89 3.875 3.45
'65-'66 3.88 3.80 2.06 1.32 0.89 4.125 3.67
'67 3.88 3.80 2.06 1.26 0.89 4.125 3.89
'68-'70 3.61 3.80 2.06 1.26 0.89 4.125 3.67
'71-'72 3.61 3.80 2.06 1.26 0.88 3.875 3.41
'72-'77 3.79 3.78 2.06 1.26 3.875
MemberJoel
Scirocco Rare
Now containing 100% E-Wang
*********


Avatar


Posts: 9368
Threads: 211
Registered: February 14th, 2006
Member Is Offline

Location: Northern Rivers NSW
Theme: UltimaBB Pro Purple
Mood: Tact Level 0.00

posted on September 3rd, 2012 at 09:13 AM



Jeff, if it's an IRS box with the 2 bolt nose cone and blank plugs like in that one of mine it should be a DC code box.

All the aus spec type 3s had a 4.125 R&P same as Sbug and 1500.
They just had a taller 3rd.
Memberbeetleboyjeff
A.k.a.: Jeff Walsh
Custom Title Time!
*****


Avatar


Posts: 1773
Threads: 40
Registered: February 13th, 2009
Member Is Offline

Location: Port Macquarie
Theme: UltimaBB Pro Blue ( Default )
Mood: Drive bugs hard

posted on September 3rd, 2012 at 09:17 AM



Thanks very much Joel. That is what I was after. :-)



From your ole' mate Jeff
Membervwo60
Veteran Volks Folk
*****


Avatar


Posts: 2036
Threads: 71
Registered: February 13th, 2007
Member Is Offline

Location: Pomona Qld
Theme: UltimaBB Psyche Blue
Mood: good

posted on September 3rd, 2012 at 05:12 PM



Any time Jeff.


  Go To Top


Powered by GaiaBB, © 2011 The GaiaBB Group
(C) 2001-2024 Aussieveedubbers

[ Queries: 40 ] [ PHP: 2.0% - SQL: 98.0% ]