| [ Total Views: 649 | Total Replies: 3 | Thread Id: 105908 ] |
|
|
 baghall
Custom Title Time!
Ben Hal Outlaw Bushranger
Posts: 1021
Threads: 131
Registered: January 15th, 2010
Member Is Offline
Location: Penrith NSW
Theme: UltimaBB Psyche Blue
Mood: Kids think I'm obsessed!
|
| posted on April 29th, 2014 at 09:18 PM |
|
|
Speedo repair
Is it possible to buy repo dials for T3 kombi speedos?
Also how hard is it to replace and recondition a speedo, i'm good with a screwdriver but have never tackled something like this before?
Thanks
68 Baja - It's a growing pain!
58 Baja ute - and the pain spreads!
85 T3 Kombi - still growing
89 T3 Kombi - parts car
|
|
|
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
|
| posted on April 29th, 2014 at 10:23 PM |
|
|
Why does it need reconditioning? Does it not work?
Very simple to clean and re-lube but unless broken or trying to change from MPH to KPH then no reason to dismantle.
Re-calibrating requires specialised tooling.
madness is in the eye of the beholder  |
|
|
baghall
Custom Title Time!
Ben Hal Outlaw Bushranger
Posts: 1021
Threads: 131
Registered: January 15th, 2010
Member Is Offline
Location: Penrith NSW
Theme: UltimaBB Psyche Blue
Mood: Kids think I'm obsessed!
|
| posted on April 29th, 2014 at 11:36 PM |
|
|
It's more it needs a new facia as far as I now. Currently not working but haven't had a chance to check why as yet. Just preparing myself for the
worst psimitar. PLan on looking at it this weekend.
68 Baja - It's a growing pain!
58 Baja ute - and the pain spreads!
85 T3 Kombi - still growing
89 T3 Kombi - parts car
|
|
|
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
|
| posted on April 30th, 2014 at 09:41 PM |
|
|
Well the needle should work so long as the square drive in the base of the input shaft hasn't become round over the years. And so long as the shaft
turns freely then not really much else can go wrong with that.
as for the odometer. That is turned by gears driven off the input shaft. Later plastic gears can be ground away much easier than the early brass
gears.
If you can find something to pop in a drill chuck that fits the square drive of the speedo then a very quick way to check if it still works. 
madness is in the eye of the beholder |
|
|
