| [ Total Views: 627 | Total Replies: 5 | Thread Id: 108127 ] |
|
|
 torana
Slammed & Awesome Dubber
Posts: 85
Threads: 20
Registered: January 18th, 2009
Member Is Offline
Location: South Aust
Theme: UltimaBB Pro Blue ( Default )
|
| posted on January 11th, 2015 at 04:49 PM |
|
|
separate heads from barrels
hi guys
is there an easy way to separate the heads from the barrels when trying to pull a motor apart?
the heads seem to be bringing the barrels off at he same time as the head.
cheers
Muz
|
|
|
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
|
| posted on January 12th, 2015 at 07:42 PM |
|
|
piece of wood and a lump hammer to try and shock them apart. Sounds like you have rust and oxidation causing them the stick together.
madness is in the eye of the beholder  |
|
|
Camo
A.k.a.: Kev
Custom Title Time!
Posts: 1936
Threads: 209
Registered: October 29th, 2007
Member Is Offline
Location: Sydney - Liverpool area
Theme: UltimaBB Pro Blue
|
| posted on January 12th, 2015 at 08:42 PM |
|
|
Compressed air into spark plug hole, best if hose has screw in type on end of it. You could also use a lever under head, but be careful not to break
barrel fins off.
|
|
|
vwo60
Veteran Volks Folk
Posts: 2036
Threads: 71
Registered: February 13th, 2007
Member Is Offline
Location: Pomona Qld
Theme: UltimaBB Psyche Blue
Mood: good
|
| posted on January 13th, 2015 at 06:18 AM |
|
|
I use a soft hammer tapping the exhaust studs only, Do not hit any other part of the head other wise you can bend of break a fin, If you use the
compressed air method as above make sure you leave the nuts on a couple of head studs, just back them off several turns.
|
|
|
torana
Slammed & Awesome Dubber
Posts: 85
Threads: 20
Registered: January 18th, 2009
Member Is Offline
Location: South Aust
Theme: UltimaBB Pro Blue ( Default )
|
| posted on January 16th, 2015 at 07:23 PM |
|
|
OK....thanks for the suggestions everyone 
will see how it goes
|
|
|
LUFTMEISTER
Veteran Volks Folk
Posts: 2041
Threads: 119
Registered: July 13th, 2005
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
Mood: BRISVEGAS in a state of flux
|
| posted on January 16th, 2015 at 09:14 PM |
|
|
Go to bottom dc and 1/2 fill gap with grease. Refit plugs and turn over by hand. Leave on some loose nuts to catch head. All good. My2c
Customer service is not dead in Australia.
Always after HAZET & MATRA & VW factory tools
|
|
|
