[ Total Views: 898 | Total Replies: 7 | Thread Id: 108449 ] |
|
ACT65Deluxe
Casual Dubber
Posts: 37
Threads: 10
Registered: April 5th, 2014
Member Is Offline
Location: Canberra
Theme: UltimaBB Pro Blue ( Default )
Mood: Always Chilled
|
posted on February 24th, 2015 at 09:02 PM |
|
|
Engine advice for a newbie
i have a stock standard 1965 Australian built beetle with the original engine (1200), and gearbox. Using an Australia (stamped) SOLEX 28 PICT carb and
6volt electrical system.
Not sure if the engine has ever been rebuilt. The speedo has just under 88,000 miles on the clock.
I love driving my beauty at every opportunity but the old dude (my son calls him Herb) seems to struggle on a long (decent) incline which is expected
for the size of the motor and its age. On the flat stuff Herb will hold 40-50mile/hr with no issues. I like the fact that the engiine is original with
all the Aussie made bits still there.
Just wondering what options are out there to get a little more power as I would love to start driving the car to some interstate shows (Sydney,
Melbourne, Berry, Valla etc) but I'm not sure the current motor set up would handle the trips.
I have seen a YouTube clip (that Chris dude in the states) saying to change the dizzy and exhaust systems and that will give you a little more
horsepower, but I thought I would ask for suggestions and/or options from the Aussie veedub community.
Rebuild? Twin carbs? Or replace?
I'm in Canberra so if a rebuild was in order who does an exceptional job here. Happy to travel interstate if there is no ACT old dub engine
builders.
Happy to spend the dollars where needed as I don't like wasting money on shortcuts or work a rounds.
Cheers Clem
Nothing beats cruising in my Beetle
|
|
matberry
Super Moderator
Go hard or go home
Posts: 8114
Threads: 134
Registered: March 7th, 2006
Member Is Offline
Location: Cooroy Qld
Theme: UltimaBB Pro Blue
Mood: enjoying waving at all my Kombi buddies from my T3
|
posted on February 24th, 2015 at 09:20 PM |
|
|
Your stock set up should do way better than that. Something is wrong with the engine, tune or a combination of things. Although Herb is getting on,
when new, his owners manual stated..."maximum AND cruising speed 75mph"
By your description he sounds like a nice original car, keep it that way, but get things working right. Start with a good service, oil change, adjust
valve clearances, new plugs and points. While your there, jack up the front and grease the front end, it's ment to be done EVERY 3000 miles.
Then, with all those fresh bits in the engine you need to tune the engine and check the distributor is working properly and set the ignition
timing....easy
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
|
|
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
|
posted on February 25th, 2015 at 06:40 PM |
|
|
Along with everything Matt said I'd also get a compression test done on the engine to see what condition it's in as a lack of servicing will lead to
rings and guide wear and both will lead to poor compression and hence a lack of power.
madness is in the eye of the beholder
|
|
ACT65Deluxe
Casual Dubber
Posts: 37
Threads: 10
Registered: April 5th, 2014
Member Is Offline
Location: Canberra
Theme: UltimaBB Pro Blue ( Default )
Mood: Always Chilled
|
posted on February 25th, 2015 at 08:36 PM |
|
|
Hi there,
Mat, I recently did all the above (new parts from Vintage VeeDub). I'm going to give it a compression test this weekend and I have a new Carb kit to
install as well.
Is there a type of Oil that the VW community recommend for a standard motor like this? I read on a thread here that its best to use an air-cooled
specific oil, and plenty of owners have their own favorites.
Any recommendation?
Nothing beats cruising in my Beetle
|
|
fish26
A.k.a.: benito
Fahrvergnugen
Posts: 903
Threads: 38
Registered: July 13th, 2007
Member Is Offline
Location: sydney
Theme: UltimaBB Pro Grey
Mood: Ken awesome
|
posted on February 25th, 2015 at 09:59 PM |
|
|
penrite hpr30
bitten by the bug..........several times
|
|
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
|
posted on February 25th, 2015 at 10:43 PM |
|
|
A 20W50 is fine too but make sure you add a zinc rich additive like Xado or Nulon or buy an oil that is high in zinc content.
madness is in the eye of the beholder
|
|
Paul Smith
Casual Dubber
Posts: 43
Threads: 6
Registered: July 17th, 2012
Member Is Offline
Location: Goodna, QLD
Theme: UltimaBB Pro Blue ( Default )
|
posted on February 26th, 2015 at 08:03 AM |
|
|
Got to be careful. Oil discussions often turn into wars. You asked for recommendations so I say 15w/40.
|
|
matberry
Super Moderator
Go hard or go home
Posts: 8114
Threads: 134
Registered: March 7th, 2006
Member Is Offline
Location: Cooroy Qld
Theme: UltimaBB Pro Blue
Mood: enjoying waving at all my Kombi buddies from my T3
|
posted on February 26th, 2015 at 02:22 PM |
|
|
Yep, do a compression test, then I'd be looking very closely at the ignition system/timing
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
|
|