| [ Total Views: 397 | Total Replies: 2 | Thread Id: 14602 ] |
|
|
 Midlife crisis
Veteran Volks Folk
Nartispuddlejumper, Bureau of Toxicity
Posts: 2282
Threads: 160
Registered: May 17th, 2003
Member Is Offline
Location: Logan city south of Brisbane
Theme: UltimaBB Pro Blue ( Default )
Mood: Wornout and Toxic
|
 posted on October 17th, 2003 at 03:56 PM |
|
|
generators pulleys
can anyone tell me how to make sure the pulleys line up when replacing the generator
thanks
marc
If you can't laugh at yourself you can't laugh at anyone else! Because life is to short not to LAUGH
|
|
|
 Bizarre
Super Moderator
The artist formerly known as blue74l
Posts: 12780
Threads: 734
Registered: August 25th, 2002
Member Is Offline
Location: Abbotsford, Sydney
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 17th, 2003 at 04:11 PM |
|
|
It just lines up
When you put the front half on (front is front) it has a key way to lock it in place. Its a bitch trying to slide the pulley on and not slide the key
out the back but it can be done.
Then the back one goes on where the tangs line up or the round/square hole over the shaft
Futue te ipsum!!!
|
|
|
Midlife crisis
Veteran Volks Folk
Nartispuddlejumper, Bureau of Toxicity
Posts: 2282
Threads: 160
Registered: May 17th, 2003
Member Is Offline
Location: Logan city south of Brisbane
Theme: UltimaBB Pro Blue ( Default )
Mood: Wornout and Toxic
|
| posted on October 17th, 2003 at 04:20 PM |
|
|
pulleys
Sorry I did not explain I meant when you are putting the genny back on the engine and line it up with the fan pulley so the fan belt is straight
thanks
Marc
If you can't laugh at yourself you can't laugh at anyone else! Because life is to short not to LAUGH
|
|
|
Bizarre
Super Moderator
The artist formerly known as blue74l
Posts: 12780
Threads: 734
Registered: August 25th, 2002
Member Is Offline
Location: Abbotsford, Sydney
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 17th, 2003 at 04:38 PM |
|
|
ok see if i understand
When the shroud goes back on it will sit the genny/alt in its cradle and again it has to line up.
The only way it cant is if the shroud isnt sitting in the cylinder covers properly
Then its not a genny problem but a tin problem
Once it is all together a piece of wood/rod/steel and a good eye will tell you if its lined up.
never had a problem putiing then back and finding it out of alignment
Futue te ipsum!!!
|
|
|
Midlife crisis
Veteran Volks Folk
Nartispuddlejumper, Bureau of Toxicity
Posts: 2282
Threads: 160
Registered: May 17th, 2003
Member Is Offline
Location: Logan city south of Brisbane
Theme: UltimaBB Pro Blue ( Default )
Mood: Wornout and Toxic
|
| posted on October 17th, 2003 at 04:45 PM |
|
|
ok will check thanks Blue
marc
If you can't laugh at yourself you can't laugh at anyone else! Because life is to short not to LAUGH
|
|
|
