| [ Total Views: 830 | Total Replies: 4 | Thread Id: 38878 ] |
|
|
 RENNWAGEN
A.k.a.: shane
Seriously Crusin Dubber
Posts: 158
Threads: 43
Registered: September 9th, 2003
Member Is Offline
Location: Sydney's Nthn Beaches
Theme: UltimaBB Pro Blue ( Default )
|
| posted on May 9th, 2005 at 06:06 PM |
|
|
Treating window sills ?
Ive just removed the windscreensfrom my splitty bit of surface rust but not too bad. What would be the best way to paint this up before replacing the
windscreens and also isnt there meant to be a drain hole in there somewhere?
|
|
|
slowbay70
Seriously Crusin Dubber
Posts: 153
Threads: 25
Registered: March 13th, 2005
Member Is Offline
Location: kingscliff
Theme: UltimaBB Pro Blue ( Default )
Mood: slow
|
| posted on May 9th, 2005 at 07:18 PM |
|
|
i dont have a splitty but yes there should be a hole, best way is to take it back to bare metal or cut it out
|
|
|
RENNWAGEN
A.k.a.: shane
Seriously Crusin Dubber
Posts: 158
Threads: 43
Registered: September 9th, 2003
Member Is Offline
Location: Sydney's Nthn Beaches
Theme: UltimaBB Pro Blue ( Default )
|
| posted on May 9th, 2005 at 07:52 PM |
|
|
Building funds for a bare metal resto but I've sanded most of the rust off and used rust converter on a few spots where it is a bit deeper now I want
to seal and paint it and stick the screens back in so I can drive it for a couple of years until it all gets done properly.
|
|
|
slowbay70
Seriously Crusin Dubber
Posts: 153
Threads: 25
Registered: March 13th, 2005
Member Is Offline
Location: kingscliff
Theme: UltimaBB Pro Blue ( Default )
Mood: slow
|
| posted on May 9th, 2005 at 08:02 PM |
|
|
you can do the small area or concern bare metal, all it takes is a bit more time on the sander, and or more paint remover, my advice is any spot you
want to deal with take it all the way back and make it shine, probably 30% more time now and no hassles later and its not a cost issue if you take the
time to sand it back
|
|
|
RENNWAGEN
A.k.a.: shane
Seriously Crusin Dubber
Posts: 158
Threads: 43
Registered: September 9th, 2003
Member Is Offline
Location: Sydney's Nthn Beaches
Theme: UltimaBB Pro Blue ( Default )
|
| posted on May 9th, 2005 at 10:51 PM |
|
|
Ihave taken all the paint off but now what is the best paint\treatmentto use in what is allways going to be a wet area. Also where are the drain
holes meant to be.
|
|
|
