| [ Total Views: 599 | Total Replies: 6 | Thread Id: 6866 ] |
|
|
 sand kombi
Officially Full-On Dubber
Posts: 345
Threads: 71
Registered: February 14th, 2003
Member Is Offline
Location: Logan Village[out skirts of Brisbane]
Theme: UltimaBB Pro Blue ( Default )
|
| posted on May 27th, 2003 at 06:20 PM |
|
|
heater installation
I have installed a 125/250watt heater in to the kombi [$40 from jaycar]. I have hooked it to a seperate switch to turn on/off instead of on the heater
it self,but I want to only work with the ignition turned on so which fuse would be best to power it,and what number is it, as the
heater will use a fair bit of power,I have also have put a fuse on the heater supply wire [25 amp].
MIKE.
VW'S DON'T LEAK OIL, THEY JUST LEAVE THEIR MARK !!!
|
|
|
phatrat
A.k.a.: steve
Fahrvergnugen
REALLY!
Posts: 891
Threads: 107
Registered: May 14th, 2004
Member Is Offline
Location: Blue Mountains (NSW)
Theme: UltimaBB Pro Blue ( Default )
Mood: Buggin Out
|
| posted on May 27th, 2003 at 07:40 PM |
|
|
Mike,
...use a test light with the ignition off...some will be constant...mark these...then turn your ignition on to red's only and test the
remainder....ok
I think a 25 amp fuse is too big. Try 10-15 amp...you want the heater to stop before anything else...
Steve
[Edited on 27-5-2003 by DakDat]
|
|
|
taths
Learner Dubber
Posts: 6
Threads: 1
Registered: May 26th, 2003
Member Is Offline
Location: sydney
Theme: UltimaBB Pro Blue ( Default )
|
| posted on May 27th, 2003 at 08:32 PM |
|
|
250watts on a 12volt system will draw 20.8amps all day long, stick with the 25amp fuse. If you pick up your supply off an existing curcuit that is
fused(e.g ignition) and the heater shorts out ...car stops ,not good(or what ever is on that circuit)Best bet is to run an in line fuse holder with
25amp fuse directly off the battery,connect to a 6mm cable .Run the cable towards the heater and connect it to a 30amp relay(if you dont run a relay
your switch will burn out in no time).Connect one side of your switch to negative(earth) and the other to the relay,this way the switch only activates
the relay, then the relay will handle all the load.The only draw back is the heater can be operated with the ignition off,but at least it wont cause
problems further down the track |
|
|
1303Steve
A.k.a.: Steve Carter
Scirocco Rare
Posts: 8650
Threads: 564
Registered: August 27th, 2002
Member Is Offline
Location: Sydney, NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Parrot Heading
|
| posted on May 27th, 2003 at 11:13 PM |
|
|
Hi
Like Jak said use a relay. Just take the power to the relay from the battery and then have the switching wire ignition controlled. Check the fuses
with a test light, some loose power when you crank the starter which is a good idea in this case.
1302Steve
|
|
|
J&SBlue
Officially Full-On Dubber
Posts: 307
Threads: 26
Registered: December 3rd, 2002
Member Is Offline
Location: Sydney - Baulkham Hills
Theme: UltimaBB Pro Blue ( Default )
|
| posted on May 28th, 2003 at 03:27 PM |
|
|
Hi Sand Kombi,
Is this heater any good ? Does it put out much heat ? Would be interested to see how well it would work in a buggy !!!!
Mark.
|
|
|
PostModern
Slammed & Awesome Dubber
Posts: 89
Threads: 8
Registered: January 31st, 2003
Member Is Offline
Location: Illawarra NSW
Theme: UltimaBB Pro Blue ( Default )
|
| posted on May 28th, 2003 at 04:06 PM |
|
|
| Quote: | Originally
posted by 1302SteveLike Jak said use a relay. Just take the power to the relay from the battery and then have the switching wire ignition
controlled.
|
*nod* The only way to do this. Ignition must be on and switch must be on for heater to operate.
I too am interested in hearing about the heater. Is it THIS ONE? (hope the link works,
stock code YS2805 $39.95?)
|
|
|
baybuscamperkid
Compulsive Aussie Vee Dubber
prince of insufficient light, ruler of heck
Posts: 4316
Threads: 335
Registered: August 25th, 2002
Member Is Offline
Location: Victoria
Theme: UltimaBB Pro Blue ( Default )
Mood: transported
|
| posted on May 28th, 2003 at 04:53 PM |
|
|
Ive got a heater in my bus too, sitting under the seat, unfortunatelt the coil or something is stuffed at the moment, so will have to do some work on
it. i wonder if sitting under the drivers seat is a clever place tho(where mine is) - restricted airflow ect?
Reimagined/Recycled/Upcycled Cool
|
|
|
sand kombi
Officially Full-On Dubber
Posts: 345
Threads: 71
Registered: February 14th, 2003
Member Is Offline
Location: Logan Village[out skirts of Brisbane]
Theme: UltimaBB Pro Blue ( Default )
|
| posted on May 28th, 2003 at 06:25 PM |
|
|
sounds like the same one. works but not great,needs to be on the 250w setting but will be needed to wired up as taths said as the switch gets really
hot. it takes a while to heat up the kombi,but no great difference just seems to be a a bit warmer,could be a lot better:beer
MIKE.
VW'S DON'T LEAK OIL, THEY JUST LEAVE THEIR MARK !!!
|
|
|
PostModern
Slammed & Awesome Dubber
Posts: 89
Threads: 8
Registered: January 31st, 2003
Member Is Offline
Location: Illawarra NSW
Theme: UltimaBB Pro Blue ( Default )
|
| posted on May 29th, 2003 at 12:16 AM |
|
|
When you think about it 250W is not really all that much heat. Just a bit more than a couple of light globes really. A small bar heater for a house
is 1500W.
|
|
|
sand kombi
Officially Full-On Dubber
Posts: 345
Threads: 71
Registered: February 14th, 2003
Member Is Offline
Location: Logan Village[out skirts of Brisbane]
Theme: UltimaBB Pro Blue ( Default )
|
| posted on May 30th, 2003 at 02:30 PM |
|
|
which type of relay would be best 4 or 5 pole ,and what is the difference
MIKE.
VW'S DON'T LEAK OIL, THEY JUST LEAVE THEIR MARK !!!
|
|
|
