Subject: installing Pop out back windows on type 3 square
satori
Wolfsburg Wizard
Posts: 497
Threads: 243
Registered: May 9th, 2008
Member Is Offline
Location: Adelaide
Theme: UltimaBB Pro Grey
posted on October 26th, 2008 at 05:40 PM
installing Pop out back windows on type 3 square
Hey guys. Can anyone give me some guidence on how to install back pop-outs on my 72 type 3 square. I have removed the old glass and rubber. How do you
attach the hidges onto the body. Are you supposed to cut slots out for them to fit in or do you have to weld something up. Also Is there suppose to be
a rubber that fits in behind the window frame as when I sit the window in place there is a grap remaining.
thanks
[URL=http://s1226
Volksaddict
Wolfsburg Wizard
Posts: 533
Threads: 102
Registered: December 25th, 2004
Member Is Offline
Location: Sawtell Mid North NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: hooked
posted on October 27th, 2008 at 10:42 AM
..there are slots on the factory fitted models ..and there is a seal around the opening
Cheers&Beers
Ray V
1500S
Custom Title Time!
Posts: 1418
Threads: 73
Registered: March 28th, 2005
Member Is Offline
Location: Nth Richmond, N.S.W
Theme: UltimaBB Pro Blue ( Default )
posted on October 27th, 2008 at 05:15 PM
Have a look at your post in the Type 3 section. Also, once you have the old fixed windows out, you will need some of the beading the same as which
clips around the door opening to trim the lip where the fixed rubber fitted. Yes you DO have to have the hinge bits welded/brazed into position once
you have found them from a donor car.
