| [ Total Views: 679 | Total Replies: 4 | Thread Id: 72915 ] |
|
|
 stretch
Learner Dubber
Posts: 10
Threads: 3
Registered: November 9th, 2008
Member Is Offline
Location: Newcastle
Theme: UltimaBB Pro Blue ( Default )
Mood: Great (most of the time)
|
| posted on November 15th, 2008 at 08:27 PM |
|
|
Floor pans ("Help needed")
Hi all,
I have just high pressure cleaned my 64-66 and found that I have large holes in both floor pans and heater chanals, and I need to replace the
floor pans (or wish the be a Flinstone) and repair the heater chanels, being new to this VW stuff, I'm after some info, cost, and the time required
to do the job.
I have access to welders and such, and I would like to think I would try most things, so I will need alot of direction with this task.
cheers
tony:
|
|
|
LUFTMEISTER
Veteran Volks Folk
Posts: 2041
Threads: 119
Registered: July 13th, 2005
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
Mood: BRISVEGAS in a state of flux
|
| posted on November 15th, 2008 at 08:33 PM |
|
|
should be lots of pics for heater chennel replacements on net. Just remember not to seperate the body from the pan till it is all lined up and braced
or you will never get it straight again. Good Luck
Customer service is not dead in Australia.
Always after HAZET & MATRA & VW factory tools
|
|
|
greedy53
Bishop of Volkswagenism
Posts: 3062
Threads: 468
Registered: March 4th, 2006
Member Is Offline
Location: camden nsw 2570
Theme: UltimaBB Pro Grey
Mood: strung out
|
| posted on November 16th, 2008 at 08:26 AM |
|
|
see classic's site they have some nice pics of parts .
and they support the forum
Classicveedub.com.au
36 Bridge St Rydalmere 2116 NSW
PH 02 96384200 FAX 02 96384266
|
|
|
stretch
Learner Dubber
Posts: 10
Threads: 3
Registered: November 9th, 2008
Member Is Offline
Location: Newcastle
Theme: UltimaBB Pro Blue ( Default )
Mood: Great (most of the time)
|
| posted on November 16th, 2008 at 04:39 PM |
|
|
Thanks for the help, I'll give them a try.
Cheers
|
|
|
Camo
A.k.a.: Kev
Custom Title Time!
Posts: 1936
Threads: 209
Registered: October 29th, 2007
Member Is Offline
Location: Sydney - Liverpool area
Theme: UltimaBB Pro Blue
|
| posted on November 16th, 2008 at 06:50 PM |
|
|
Hi Tony,
If you look up the "Bug Me" video site (see link below), Volume 6 (Floorpan Repair) and Volume 7 (Heater Channel & Panel Replacement) they are a
very good starting point and will definitely give you the push to do it yourself. I have them both and they were a great starting point, but I
didn't need to replace either. I repaired a section of floorpan and heater channels were ok.
Also look on ebay for them (World wide).
Click here for Bug Me site.
Good luck, Kev
|
|
|
