Posts: 26
Threads: 15
Registered: August 4th, 2009
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on September 29th, 2009 at 10:26 PM
type 3 bearing/drive flange setup
Hi,
I'm just putting my buggy back together... it runs type 3 drive flanges on the rear...now, my question is about the bearing/flange setup. Working
from the inside out on the splined "drive shaft" (which the drive flange slides onto), there is a small sleeve, which runs inside the seal, then a
bearing (ball), then another tube spacer, then the outer bearing (roller), then enother sleeve (which runs inside the outer seal).... this sleeve has
a chamfer on the inner surface on one side (and none on the other). Does anyone know if the chamfer faces inwards (to the roller bearing), or outwards
(to the drive flange)?
thanks,
Chris
cb john
Wolfsburg Wizard
Posts: 470
Threads: 6
Registered: June 22nd, 2007
Member Is Offline
Location: Sydney
Theme: UltimaBB Pro Blue
posted on September 29th, 2009 at 10:32 PM
inwards
bajachris88
A.k.a.: Chris Leete
23 Windows of Awesome
The international telephone dialing code for Antarctica is 672.
Posts: 6661
Threads: 534
Registered: April 8th, 2005
Member Is Offline
Location: Tanah Merah, SE-QLD
Theme: UltimaBB Pro Blue ( Default )
Mood: A bee bit ma' bottom, now ma' bottom's big!
posted on September 29th, 2009 at 10:52 PM
I had this issue myself just a few months ago.
Definitely as John said.
(ô_!_/ô) (ô_!_/ô)
69' baja: kombi box, thing spindles, irs, disc front, type 3 rear drums, 2 inch lift kit, 31x10 rears.
New engine in process: 94mm p&bs, 74mm C/w chomol Crank, 35.5x39 SP heads, turbo. Wierd combo, hopeful torque monsta!
