Posts: 792
Threads: 330
Registered: April 21st, 2005
Member Is Offline
Location: Kembla Grange, NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: GETTING FASTER
posted on August 5th, 2010 at 07:22 PM
FS-NSW- Freshened 1916cc engine
I purchased a complete engine in the US last November as it was supposedly only done 5000 miles . I stripped the engine and have freshened it up with
the following components ;
Used magnesium case , std thrust and first oversize
Std late crank std/std
Std reco conrods
New Engle w 110 cam
New Scat solid lifters
New pushrod tubes
Used 94mm piston/barrel kit , Honed with approx 5000 miles
Used Melling steel oil pump
Reco 041 heads with 40mm stainless intake and 35.5mm stainless exhaust valves , fresh valve job , hand ported
New solid shimmed rocker kit with swivel feet adjusters
Std flywheel
This engine should be good for around 100 hp and has a compression ratio of 8.8:1 . I am asking $ 3000 for this engine and would work well with a set
of 40mm dellorto's for and extra $ 600 . This is located in Wollongong NSW and can be shipped Australia wide , ROD , 02-42729920
More boost + More fuel = More power
1968 Beetle fastest run 8.96 sec @ 161 mph 4th Nov. 2001
2010 New Beetle 8.12 sec on 8th march 2014 http://www.rodpenroseracing.com.au
Ollie
A.k.a.: Ollie Clarke
Insano Dub Head
Yeah Buddy
Posts: 840
Threads: 122
Registered: October 5th, 2009
Member Is Offline
Location: Sydney
Theme: UltimaBB Streamlined2
Mood: Hungry for another 676cc
posted on August 5th, 2010 at 07:22 PM
