Posts: 1083
Threads: 74
Registered: October 1st, 2003
Member Is Offline
Location: Gold Coast, Qld
Theme: UltimaBB Pro Blue ( Default )
Mood: Just cured my shed envy!
posted on May 17th, 2011 at 10:44 AM
Manifold modifications
My '63 Beetle is currently fitted with what is believed to be a 1600 SP (I say 'belived' because it was removed from a wreck and dropped into my
'63 at short notice and without any testing or measuring) and was only supposed to be a temporary measure until I had time to build something
better....
It has actually turned out to be a really reliable engine, so the need to build another engine has lost some of it's urgency, however it has one very
annoying problem that is getting worse now that the weather has turned cold...
The manifold pre-heat tubes are damaged (burnt-out) and have been blocked off where the manifold meets the exhaust. This, coupled with a rather worn
30PICT carb causes it to cough and backfire at low revs almost all the time - although it does improve once a little heat has soaked into the
manifold.
I was thinking of fitting a different carb to the car to eliminate the problem with the worn 30PICT (which is a 1300 carb anyway), and I may as well
fix the manifold pre-heat problem while I am there...
I have a 34 PICT-3 from a later model 1600 TP that has been recently rebuilt but this does not fit onto the SP manifold (mounting base is a diferent
size), so I was wondering what my options are....
I have a number of TP manifolds (the 3 piece ones) kicking around in my shed... does anyone know if it is possible to make a single port version,
using the center of the TP manifold and by cutting the ends off a SP manifold? Has it been done before? Did it work OK? I imagine that the only
issue will be getting the manifold ends to seal to the TP centre section... or is there more to it than that?
My other option is to fit dual carbs, I have a set of Type III carbs and manifolds off a 1500 Type III motor, but I would have to create a throttle
linkage and come up with a set of air filters that will fit inside an early Beetle engine bay....
What would your choice be?
R
40hp, 6V and ...er... slowly making improvements
It's nice to be important, but it's more important to be nice!
Originally
posted by ratty 63
I have a number of TP manifolds (the 3 piece ones) kicking around in my shed... does anyone know if it is possible to make a single port version,
using the center of the TP manifold and by cutting the ends off a SP manifold? Has it been done before? Did it work OK? I imagine that the only
issue will be getting the manifold ends to seal to the TP centre section... or is there more to it than that?
It's been done, the single port 1300-1600 manifold OD is roughly the same size as the TP center section so you just make end pieces and find some
rubber hose, I used radiator hose, seem to hold up fine to fuel.
You can probably do it with an adapter though,
I've got one of those common one which fit a 30-31 carb to a 34 manifold, they might work upside down.
There's abit of work making type3 cars fit an upright motor.
I've done it before and it gives really good results but I had to completely re engineer the linkage system and mod the manifolds abit.
posted on May 17th, 2011 at 10:44 AM
