Board Logo
Go To Bottom

Printable Version  
[ Total Views: 494 | Total Replies: 3 | Thread Id: 93839 ]
Author: Subject:  mainfold should it run hot or cold etc
Memberdubai
Seriously Crusin Dubber
**


No Avatar


Posts: 161
Threads: 67
Registered: October 15th, 2009
Member Is Offline

Theme: UltimaBB Pro Blue ( Default )

yes.gif posted on November 16th, 2011 at 09:33 PM
mainfold should it run hot or cold etc


I recently built a new 1600 motor and put a new rebuilt 30 pict carb on it. With my old 1200 engine28 pict carb the inlet manifold ran cold and even had condensation. The new 1600 with the 30pict runs hot with no condensation so far I have adjusted the idle screen and the air fuel mix screen what else do I need to do or is this normal whats it meant to do? thanks guys
Member1303Steve
A.k.a.: Steve Carter
Scirocco Rare
*********


Avatar


Posts: 8636
Threads: 559
Registered: August 27th, 2002
Member Is Offline

Location: Sydney, NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Parrot Heading

posted on November 16th, 2011 at 10:14 PM



Hi

The preheat tube should sizzle if you lick your finger and touch the heat riser. The old one was probably blocked.

Steve
Member68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
**********


Avatar


Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline

Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -

yes.gif posted on November 16th, 2011 at 10:38 PM



Quote:
Originally posted by dubai
I recently built a new 1600 motor and put a new rebuilt 30 pict carb on it. With my old 1200 engine28 pict carb the inlet manifold ran cold and even had condensation. The new 1600 with the 30pict runs hot with no condensation so far I have adjusted the idle screen and the air fuel mix screen what else do I need to do or is this normal whats it meant to do? thanks guys


Hi
the exhaust gases run thru the bottom of the inlet manifold from one side to the other heating it up to stop the carby from icing up..
so, its normal...
I had to change My manifold as the heatriser part was blocked and rusted out..
My carby used to ice up when the temperature was cold... like 0-8 degrees C

cheers

LEE




LEE




- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
Memberdubai
Seriously Crusin Dubber
**


No Avatar


Posts: 161
Threads: 67
Registered: October 15th, 2009
Member Is Offline

Theme: UltimaBB Pro Blue ( Default )

posted on November 17th, 2011 at 07:32 AM



Thanks guys


  Go To Top


Powered by GaiaBB, © 2011 The GaiaBB Group
(C) 2001-2024 Aussieveedubbers

[ Queries: 40 ] [ PHP: 2.5% - SQL: 97.5% ]