| [ Total Views: 542 | Total Replies: 4 | Thread Id: 96136 ] |
|
|
 Mattriots
Seriously Crusin Dubber
Posts: 131
Threads: 26
Registered: September 6th, 2011
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on March 31st, 2012 at 03:16 PM |
|
|
Accelerator pump arm hits fan shroud
Hi
Just installed a brand new single port manifold as my old one had a crack in it
It's on a 1300 and I'm running a H30/31 carb
I've put everything back together and now the accelerator pump arm is pretty much hard up against the fan shroud!
Have I put everything back on incorrectly? Or is there some way to adjust the fan shroud away from the carb? Any tricks or mods??
Thanks for your help
Matthew
|
|
|
Mattriots
Seriously Crusin Dubber
Posts: 131
Threads: 26
Registered: September 6th, 2011
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on March 31st, 2012 at 03:31 PM |
|
|
Oh it's a beetle by the way
|
|
|
cb john
Wolfsburg Wizard
Posts: 470
Threads: 6
Registered: June 22nd, 2007
Member Is Offline
Location: Sydney
Theme: UltimaBB Pro Blue
|
| posted on March 31st, 2012 at 05:35 PM |
|
|
Just measure old and new manifold an you'll see difference...
|
|
|
Mattriots
Seriously Crusin Dubber
Posts: 131
Threads: 26
Registered: September 6th, 2011
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on March 31st, 2012 at 06:17 PM |
|
|
Yeah I put them side by side, and I couldn't seeany difference
There must be a tiny amount of difference with some of the bends
I managed to massage it into place a bit better
But there is still a bit of contact with the acc arm at full push
I might tighten the arm up a bit so I'm still getting the mist squirt possible
Then if all else fails, I'll grind a little off the acc pump arm bracket bit
|
|
|
Mattriots
Seriously Crusin Dubber
Posts: 131
Threads: 26
Registered: September 6th, 2011
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on April 4th, 2012 at 05:11 PM |
|
|
I dremelled the hell outta it, so now it doesn't foul on the fan shroud
But I still can't get it to squirt enough straight away. It squirts enough further along the stroke, but just not quite enough initially
Any ideas???
|
|
|
