Posts: 10
Threads: 3
Registered: April 22nd, 2012
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on May 8th, 2012 at 12:52 PM
56 oval
hi all im hoping that you guys can guide me in setting up my 56 so it can handel/ stop and go? will start getting parts and putting them aside to do a
full on rebuild.
i want to stay wide 5 and will run disc`s want to lower it but not sure if just go with drop spindels?as iwant a car that can go around corners ect,
so does that mean not a narrowed beam? and run slightly wider guards, front and rear for wider rims and tyres.
the motor thats in her at the moment is a 1500 single port but has the stock tranny. so what tranny would you recomend to fit, and what to do so to
make a swing axel rear end work better ie sway bars, camber things? sorry for the long post . but its great sites like this for vdub freaks .
note im off to taiwan end of the monthe and hope to drop into vintage spares, if any one needs some small item from there ill see what i can do
ian.mezz
Wolfsburg Elder
I never said, I could write or spell
Posts: 3913
Threads: 280
Registered: September 11th, 2004
Member Is Offline
Location: Newcastle
Theme: UltimaBB Pro Blue ( Default )
Mood: Happy
posted on May 11th, 2012 at 07:51 PM
show us how it looks now???
car forums. where a lot of peoples good intentions end up taking a good old car off the road forever never ever to see the road again.
pogmahon
Learner Dubber
Posts: 10
Threads: 3
Registered: April 22nd, 2012
Member Is Offline
