Board Logo
Go To Bottom

Printable Version  
[ Total Views: 1105 | Total Replies: 12 | Thread Id: 98598 ]
Author: Subject:  Petrol smell
MemberBlue65
A.k.a.: Yau
Officially Full-On Dubber
***


Avatar


Posts: 298
Threads: 93
Registered: September 30th, 2002
Member Is Offline

Location: Melbourne
Theme: UltimaBB Pro Blue ( Default )
Mood: Retrospective

posted on August 30th, 2012 at 12:44 AM
Petrol smell


Hi - it seems petrol is splashing out of the cap (just a tiny bit) when I go driving. I've tried various petrol caps but I can still smell the occasional smell of petrol when I turn a corner hard or brake hard. Is there any remedy for this?



______________________
Owner of a 1964 VW Beetle, 1641cc engine, etc..
Membertoey1984
A.k.a.: nathan kirkman
Commited Dubber
**


Avatar


Posts: 73
Threads: 11
Registered: February 26th, 2012
Member Is Offline

Location: telegraph point
Theme: UltimaBB Pro Blue
Mood: skittels

posted on August 30th, 2012 at 02:24 AM



Hi, guessing its in a early beetle?
Other than knowing its the correct cap for that tank and putting new cork / rubber seals in the cap ( was a problem with my old buggy) and make sure breather piping as crack free ( as this too could be your smell if it's not the cap itself)




Nathan
MemberBlue65
A.k.a.: Yau
Officially Full-On Dubber
***


Avatar


Posts: 298
Threads: 93
Registered: September 30th, 2002
Member Is Offline

Location: Melbourne
Theme: UltimaBB Pro Blue ( Default )
Mood: Retrospective

posted on August 31st, 2012 at 12:44 AM



Quote:
Originally posted by toey1984
Hi, guessing its in a early beetle?
Other than knowing its the correct cap for that tank and putting new cork / rubber seals in the cap ( was a problem with my old buggy) and make sure breather piping as crack free ( as this too could be your smell if it's not the cap itself)


Yes, its a 1960s era Beetle. Did all that. Maybe I'll try it again.




______________________
Owner of a 1964 VW Beetle, 1641cc engine, etc..
Membersilver
Veteran Volks Folk
Dangerous when poked
*****


Avatar


Posts: 2169
Threads: 162
Registered: December 8th, 2002
Member Is Offline

Location: Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: In 2 Minds

posted on August 31st, 2012 at 08:04 AM



check the seal under the fuel gauge sender



Keeping it real !
Member68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
**********


Avatar


Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline

Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -

posted on August 31st, 2012 at 01:04 PM



Quote:
Originally posted by Blue65
Hi - it seems petrol is splashing out of the cap (just a tiny bit) when I go driving. I've tried various petrol caps but I can still smell the occasional smell of petrol when I turn a corner hard or brake hard. Is there any remedy for this?


I can remember the 65 beetle fuel caps and they weren't very well made...

You may need to find a rubber washer to put on it...
the original washer will shrink or be pushed in over many years..
a new cap or washer should fix the problem of fuel smell...

LEE




- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
Memberbajachris88
A.k.a.: Chris Leete
23 Windows of Awesome
The international telephone dialing code for Antarctica is 672.
********


Avatar


Posts: 6661
Threads: 534
Registered: April 8th, 2005
Member Is Offline

Location: Tanah Merah, SE-QLD
Theme: UltimaBB Pro Blue ( Default )
Mood: A bee bit ma' bottom, now ma' bottom's big!

posted on August 31st, 2012 at 06:07 PM



Maybe relevant, but i was in the same situation.

See, the stock breather pipe for my 69' goes from the filler neck, under the dash and back towards the tank near the passenger side then out under the front wheel arch area on the passenger side. When i'd fill the tank up, particularly when taking right turns i'd get a fuel odour, and upon investigation i culd see the breather pipe outlet near the wheel arch was damp. This 'seems' like the normal operation, but when full it allowed the excess to creep up and out and maybe loose a few mL's of petrol which didn't bother me but would certainly make a smell.

NOW! Where I am going, is the reason i could smell the fuel on the outside during the normal breather operation, was because of the bonnet seal and the seals for the indicators not being present (I believe). When you drive the cabin is often under vacuum (bernoulli's effect with windows down or the vacuum from the rear of the car passing into the engine bay and channels in the roof as you drive), and this causes the cabin to suck in air from the outside at the front into the bonnet, into the cabin (through the speaker grills, dash holes, demister vents etc). and thus, because i had no seals for my indicators, nor any bonnet seal, the fumes from the petrol breather at the front could pass into the cabin easily and get 'sucked in'.

After going nuts with silicone around the indicator wire holes and fitting a seal on the bonnet, it has cured it! Could possibly be the same cause for yours if there are unsealed openings from the bonnet into atmosphere. (This includes holes for the inspection plate covers).




(ô_!_/ô) (ô_!_/ô)
69' baja: kombi box, thing spindles, irs, disc front, type 3 rear drums, 2 inch lift kit, 31x10 rears. :tu:
New engine in process: 94mm p&bs, 74mm C/w chomol Crank, 35.5x39 SP heads, turbo. Wierd combo, hopeful torque monsta!
MemberBlue65
A.k.a.: Yau
Officially Full-On Dubber
***


Avatar


Posts: 298
Threads: 93
Registered: September 30th, 2002
Member Is Offline

Location: Melbourne
Theme: UltimaBB Pro Blue ( Default )
Mood: Retrospective

posted on September 3rd, 2012 at 04:06 PM



Quote:
Originally posted by 68AutoBug
Quote:
Originally posted by Blue65
Hi - it seems petrol is splashing out of the cap (just a tiny bit) when I go driving. I've tried various petrol caps but I can still smell the occasional smell of petrol when I turn a corner hard or brake hard. Is there any remedy for this?


I can remember the 65 beetle fuel caps and they weren't very well made...

You may need to find a rubber washer to put on it...
the original washer will shrink or be pushed in over many years..
a new cap or washer should fix the problem of fuel smell...

LEE


I've changed the washer twice. But I have noticed that when I pour in new petrol, the washer area is wet with petrol that has splashed upwards.




______________________
Owner of a 1964 VW Beetle, 1641cc engine, etc..
Super Administratorvw54
Super Administrator
Always Waiting 4 Friday
*********

Rank Avatar

No Avatar


Posts: 16723
Threads: 378
Registered: August 26th, 2002
Member Is Offline

Location: Sunny Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: Oval resto ongoing

posted on September 3rd, 2012 at 08:36 PM



check the small vent tube on the filler neck and the tube as well

if this is blocked it will pressurise the tank and force the fuel vapours past the cap gasket




MemberBlue65
A.k.a.: Yau
Officially Full-On Dubber
***


Avatar


Posts: 298
Threads: 93
Registered: September 30th, 2002
Member Is Offline

Location: Melbourne
Theme: UltimaBB Pro Blue ( Default )
Mood: Retrospective

posted on September 21st, 2012 at 09:33 PM



Quote:
Originally posted by vw54
check the small vent tube on the filler neck and the tube as well

if this is blocked it will pressurise the tank and force the fuel vapours past the cap gasket


I checked the tube. Its OK. However the metal vent tube seems to have been pinched on the inside - inside the tank. Is that normal?

I squirted some WD40 from one side of the metal tube and the vapour does go through somewhat.

I made the opening even and I hope that will help.




______________________
Owner of a 1964 VW Beetle, 1641cc engine, etc..
MemberBlue65
A.k.a.: Yau
Officially Full-On Dubber
***


Avatar


Posts: 298
Threads: 93
Registered: September 30th, 2002
Member Is Offline

Location: Melbourne
Theme: UltimaBB Pro Blue ( Default )
Mood: Retrospective

posted on February 11th, 2013 at 11:37 AM



Just to conclude this discussion - I am happy to let everyone know that after I unpinched the vapor slot in the fuel tank neck - the issue of vapor fumes has largely gone away.

I think the previous owner clamped the vapor slot thinking it would solve the fuel vapor problem. What he probably didn't realize was that fuel line that runs inside the car chassis spine tunnel had rusted and was leaking - I got Volkscare to fix that.

Most of the vapor fumes are noticable esp after I pump in the fuel. But it does occur in rare odd moments when I'm doing normal easy driving.




______________________
Owner of a 1964 VW Beetle, 1641cc engine, etc..
Membervlad01
Compulsive Aussie Vee Dubber
*******


Avatar


Posts: 4270
Threads: 109
Registered: June 3rd, 2010
Member Is Offline

Location: Kyneton, VIC
Theme: UltimaBB Pro Blue ( Default )
Mood: Side ways

posted on February 12th, 2013 at 02:01 PM



Quote:
Originally posted by bajachris88
Maybe relevant, but i was in the same situation.

See, the stock breather pipe for my 69' goes from the filler neck, under the dash and back towards the tank near the passenger side then out under the front wheel arch area on the passenger side. When i'd fill the tank up, particularly when taking right turns i'd get a fuel odour, and upon investigation i culd see the breather pipe outlet near the wheel arch was damp. This 'seems' like the normal operation, but when full it allowed the excess to creep up and out and maybe loose a few mL's of petrol which didn't bother me but would certainly make a smell.

NOW! Where I am going, is the reason i could smell the fuel on the outside during the normal breather operation, was because of the bonnet seal and the seals for the indicators not being present (I believe). When you drive the cabin is often under vacuum (bernoulli's effect with windows down or the vacuum from the rear of the car passing into the engine bay and channels in the roof as you drive), and this causes the cabin to suck in air from the outside at the front into the bonnet, into the cabin (through the speaker grills, dash holes, demister vents etc). and thus, because i had no seals for my indicators, nor any bonnet seal, the fumes from the petrol breather at the front could pass into the cabin easily and get 'sucked in'.

After going nuts with silicone around the indicator wire holes and fitting a seal on the bonnet, it has cured it! Could possibly be the same cause for yours if there are unsealed openings from the bonnet into atmosphere. (This includes holes for the inspection plate covers).


I get fuel smell for my work car coming from the front but the leaks are in the rear (leaking breather hoses and main filler hose, love todays "improved fuel") the vacuum under the car pulls the fumes up and around the car and into the front windows when down.

sounds similar to that.




http://i1015.photobucket.com/albums/af278/vladk01/notch04.png
71 notchback,
Past owner of, 70 NB, 73 SB and 72 FB TLE
Member68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
**********


Avatar


Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline

Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -

posted on February 12th, 2013 at 04:05 PM



Quote:
Originally posted by silver
check the seal under the fuel gauge sender


well, I had My sender out to fix a couple of rusted holes in My tank..
I repaired from the nside and outside...

Now the seal for the sender does leak... even though I have tried permatex, which has helped except for very hot days...
when the fuel expands...
I tend Not to fill the tank right up.. lol

I'll just have to replace the seal...
and recheck all the breather hoses too...
I have lost one of the screw plastic seals too...??
where I had an earth wire...

LEE




- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
Memberempi
A.k.a.: Empstar
Compulsive Aussie Vee Dubber
*******


Avatar


Posts: 4131
Threads: 178
Registered: August 27th, 2002
Member Is Offline

Location: melbourne
Theme: UltimaBB Pro Blue ( Default )
Mood: thunderous

posted on February 13th, 2013 at 08:29 AM



check sender seal, cap seal and breather pipe near the cap is attached.



"If at first you don't succeed, skydiving is not for you." - Anonymous :ninja:


  Go To Top


Powered by GaiaBB, © 2011 The GaiaBB Group
(C) 2001-2024 Aussieveedubbers

[ Queries: 40 ] [ PHP: 2.7% - SQL: 97.3% ]