I need to find a better solution for my throttle cable. I had made up a tube and flared the end but the cable is cutting through the tube and I’m sure it won’t be long before it cuts through my cable. Someone must have come up with a better idea.
The cut in the tube is from 700km of driving only.
How about a small steel wheel? So the cable can roll on it rather than drag across a tube?
It will all be OK in the end, if it's not OK it's not the end!
Out on a limb here - but why not move the arm one hex side down
I never had a problem with the linkage set up on a Type 1 motor with hex bar
Futue te ipsum!!!
looks like the arm is set to high.
most vw cable works fine on twin webbers.
its a bit hard to tell but looks like you need to rework the linkage angles
😂🤪😂🤪😂
car forums. where a lot of peoples good intentions end up taking a good old car off the road forever never ever to see the road again. 🥲
It is an aftermarket shroud - is the tube in the wrong spot?
Futue te ipsum!!!
typical EMPI product buy shit have shit
GET an original fan shroud shouldn't be any problems then
CHINESE CHROME JUNK
just don't buy it
I had a similar problem with a aftermarket shroud, i slotted the hole in the shroud upwards, then put a radius in the tube and silver solded a small cover plate on the end to cover the slot, i agree the arm is mounted in the wrong position on the cross bar, you might have to adjust the length of the linkage rods on the carbs when you reposition the arm, then the cable will need to be shortened.
