Ok not to keen to do this but shit happens.
Item: I have for sale a 1968 ball joint, swing axle rear rolling pan for sale.
Condition: Reconditioned. Left and right pan halfs replaced (properly - that is old pan haves un-picked and new halves spot welded on) lower front bulk head replaced. The old one had some rust holes in the grooves and i didn't want to bodgey it.
Front end recoditioned - new needle bearings and seals, selecta drop installed for raising front (un-adjusted sits at normal height), new monroe shockies.
Gearbox degreased and new rubber boots installed. have seals to do outer wheel bearings but haven't got to it (the old ones dont leak anyway) New brake cylinder and all new brake lines and hoses. It has a cutting brake installed as well. This seperates the left and right rear brake lines and allows independent application of the rear brakes via a handle to increase turning and or traction.
A few other bits and peices as well like pedals/cables etc.
This was to be the base of my baja but circumstances have changed.
Contact: Sam 0407426059 or txt/pm (can't always answer phone during office hours)
Location: just out of Warwick, Queensland.
Price: $700 neg
Photos: Will get some of the underside as it has a body sitting on it full of the project pieces.
bluebaja Officially Full-On Dubber
233 posts · joined Oct 2003 ·
