Skip to content
Aussieveedubbers

AA Piston kits

0 likes
Share Share on Facebook Share on X Share on Reddit

GottaSplit Seriously Crusin Dubber

101 posts · joined Nov 2010 ·

#992045
Hey guys...
As per the title, have any of you guys bought/installed these kits? I have looked at their website a few months ago, just weighing up my options.
As I am close to getting my Beetle on the road. Its a stock stale air 40hp, was looking at their big bore 40 horse kit just to freshen it up and give it a little more oomph....
Maybe even buy the 1916 kit as well for my bus.

cheers Jamie
1960 11 Window

Bizarre Moderator The artist formerly known as blue74l

12,785 posts · joined Aug 2002 ·

#992050
I have heard good and bad about them

Mahle, JE or Wiseco would be better
Anything forged rather than cast - which i am pretty sure is what AA is

For under a 6,000 rev mid power motor I reckon they would be fine

Doubt I would use them in an 8,000 rev 150HP stonker
Futue te ipsum!!!

fish26 Fahrvergnugen

903 posts · joined Jul 2007 ·

#992056
AA 40hp kit consists of cast iron cylinders and Hypereutectic pistons which will be fine for your and most applications.

Since hypereutectic pistons are stronger than the old fashioned cast in steel supported skirt cast pistons the rules have changed and unless you need the extra strength of forged it is unlikely you need anything more. The other consideration is forged pistons need more clearance of a eutectic piston and usually wear the rings faster due to piston rock.
bitten by the bug..........several times

Stanley I guess the reward is in the doing of it

4,523 posts · joined Mar 2003 ·

#992072
Ran AA 87mm kit in my notch for a few years...still going strong as far as i know.

FROSTY Insano Dub Head

744 posts · joined May 2009 ·

#992114
I'm currently running (flogging the shit out of) AA 1776 piston and cylinder kit (69mm stroke) in my drag car, i have had them to 8000rpm and no problems (yet) i have run8.04 on the 1/8th and 12.75 1/4. I would have no hesitation using them in a road car. (this is my opinion)
thanks
Jason

bajachris88 The international telephone dialing code for Antarctica is 6

6,661 posts · joined Apr 2005 ·

#992141
I have AA 94mm piston kit. Crankshaft engineering didn't have any complaints or issues balancing em'.

After a long background check on Samba, the racer boys were keen on em' as the pistons are lighter than other competitors products, reducing the reciprocating mass 🙂.
(ô_!_/ô) (ô_!_/ô)
69' baja: kombi box, thing spindles, irs, disc front, type 3 rear drums, 2 inch lift kit, 31x10 rears. 👍
New engine in process: 94mm p&bs, 74mm C/w chomol Crank, 35.5x39 SP heads, turbo. Wierd combo, hopeful torque monsta!