Hi all new to the forum so apologies if rehashing.
Have a 67 bug only since march, registered and runner etc but certainly a long term project for fixing up. Done some basics general service ie oils, plugs leads changed to elec ignition, valves etc. Put on standard 2.5 drop spindles and disc brakes on the front having some clearance issues with that but never mind.
Anyway question is, the engine bay missing the rubber seals etc to aid cooling. The channels are pretty stuffed in that trying to do with the motor in be near impossible I think and I really don't want to the pull the motor at this stage as it will open a big can of worms I think but leaving alone should save the dramas for now. Eventually the whole thing will be blown apart and engine most likely replace for a 1500-1600 but thats a fair way down the track.
I was thinking of getting some of that exhaust wrap to put around the muffler etc and for temporary get some of that aluminum heat shield stuff that you can cut and manipulate and screw in around roughly where the rubber should be. Anyone done/ used similar before and helped?
As I say eventually the whole car will be blown apart and panels, rubber etc etc will be replaced but just going to start getting the majority first bit by bit before start that so going to be a while, but at least the wife can still run it around occasionally be luck for once a week gets the car out for a run but being in qld certainly hot.
Anyway thank you in advance for any help, suggestions you may have. I suspect I'll have many questions along the way.
thanks
vincew Learner Dubber
7 posts · joined Apr 2020 ·
