Skip to content
Aussieveedubbers

Removing/replacing front beam

0 likes
Share Share on Facebook Share on X Share on Reddit

karmannghia60 Karmann Ghia Sucker

1,459 posts · joined Aug 2002 ·

#99381
This is on my '60 Ghia. Would removing the fuel tank make the job easier? Do I get better access to the top nuts? The PO welded the top of the beam to the frame head so I need to cut through it with an angle grinder or something. I can't see how I can do that from under the car!
Raf

[Edited on 15-10-2003 by karmannghia60]

wadd Seriously Crusin Dubber

179 posts · joined Apr 2003 ·

#99398
it does on a beetle ...no help i know if tank is over the front beam it may be the same as

geodon Wolfsburg Wizard

478 posts · joined Aug 2002 ·

#99426
Seeing it's so easy to remove the tank, why not?
Also if you are using a trolley jack to lower it, you can stand over the top & steady it as it goes down.
Geez, I bought a 62 beetle 30 years ago that had that done to it, supposedly to stop front end shimmy. Take a good hard look at it- there may be be a bent frame head involved.

[Edited on 15-10-2003 by geodon]

karmannghia60 Karmann Ghia Sucker

1,459 posts · joined Aug 2002 ·

#99470
Why would they weld it if it was a bent frame? I thought maybe the frame was rusted where the bolts go through but its not the case. I had a good look

68AutoBug Beetle Restorer - Experience over 138\% - YIKES --

11,654 posts · joined Aug 2002 ·

#99489
Karmann Ghia60
The PO or whoever did it may have just bought a new welder... why else would You do it... Maybe they thought that 6 bolts were not enough to hold the front end into place....
Yes, with the Beetle its MUCH easier with the tank Out... I have just done mine, replaced everything on the front end, ball joints tie rod ends etc... I now have the tank in, and its nearly impossible to do anything... and don't forget the top two bolts on the opposite side of the torsion bars.. You can get New rubber blocks from Mick Motors... cheers.. Lee

1 attachment · Log in to view

- Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY---

geodon Wolfsburg Wizard

478 posts · joined Aug 2002 ·

#99785
If I remember rightly, it had had a head on & been fixed. The mounting bolts were not able to fix the FE on firmly enough to prevent the steering wheel ( & front wheels?) shimmying & car repairers I spoke to at the time said welding the FE on was a way around it. So why was yours welded on in the 1st place? Mounting bolts stripped perhaps??

vw54 Administrator Always Waiting 4 Friday

16,723 posts · joined Aug 2002 ·

#99794
YES remove the fuel its only 4 bolts and the hose.

this way you can get to the tie rod ends easier as well.
I read it on FACEBOOK so it must be true


http://forums.aussieveedubbers.com/viewtopic.php?tid=91278&page=1#pid848630


http://forums.aussieveedubbers.com/viewtopic.php?tid=63561&page=1#pid624099


http://forums.aussieveedubbers.com/viewtopic.php?tid=4832&page=1#pid452603


http://forums.aussieveedubbers.com/viewtopic.php?tid=60650&page=1#pid574409