CHADMYSTER Seriously Crusin Dubber
171 posts · joined May 2004 ·
can anyone tell me the minimum thickness allowed for front disc rotors. i have a 69 beetle and the drivers side has a slight warp but the rotors dont look very thick.
front disc rotors minimum thickness
1303Steve Scirocco Rare
8,650 posts · joined Aug 2002 ·
Its 8.5 mm
General_Failure Use your head, don't abuse it!
1,036 posts · joined Jun 2004 ·
If they don't look all that juicy, and one of them has a warp, replace them. They aren't the most expensive things in the world.
Sometimes, by the time the warp is machined out of them, they are outside tolerance for thickness. Also, when they warp, it means the whole grain of the metal bends, and they will probably warp again.
There's nothing nicer than a pair of new discs on a shaky beetle. Trust me, I have an S 😀
Sometimes, by the time the warp is machined out of them, they are outside tolerance for thickness. Also, when they warp, it means the whole grain of the metal bends, and they will probably warp again.
There's nothing nicer than a pair of new discs on a shaky beetle. Trust me, I have an S 😀
If at first you don't succeed. Build, build again.
Vehicle: 1975 Special order delivery walkthrough panel based LCA pop-top camper. Motor: Nippon 1.8L Single port Wasserboxer, Transmission: 3 rib 002.
Vehicle: 1975 Special order delivery walkthrough panel based LCA pop-top camper. Motor: Nippon 1.8L Single port Wasserboxer, Transmission: 3 rib 002.