A Quicky Tech Q

VolksFolks Son of Jim - Creator of Good

2,869 posts · joined Dec 2003 · 21 Jul 2004, 11:39 am

#205562

What is the size of the large pushrod tube 'O' ring, the one that fits into the crankcase, is it 25mm or 1 inch, i canna remember, it is a 1800 motor

Thanks Andy

They laugh because You are different, You laugh because They are all the same.

check out www.lowlight.com.au for low lights only..

BiX Veteran Volks Folk

2,499 posts · joined Sep 2002 · 21 Jul 2004, 1:17 pm

#205609

as one inch = 25.4mm ther would be little difference and with production tolerances it shouldn't matter

I have no sympathy for my car, only the wallet that pays for it!
Go hard or go home!!!!

VolksFolks Son of Jim - Creator of Good

2,869 posts · joined Dec 2003 · 21 Jul 2004, 1:21 pm

#205610

so are they 25.4mm, i need to get replacements

Andy

They laugh because You are different, You laugh because They are all the same.

check out www.lowlight.com.au for low lights only..

KruizinKombi Seriously Obsessed Cyber Dubber

3,493 posts · joined Aug 2002 · 21 Jul 2004, 2:24 pm

#205638

Make sure you get the German ones.... the cheaper varieties tend to go hard and leak prematurely. 🙂

Kruizin Kol

Madeline Learner Dubber

11 posts · joined Jul 2004 · 21 Jul 2004, 9:16 pm

#205903

The inner ones (case side) are black & smaller.The outer ones (head side) are either red,green or yellow & are larger of the two.Try not to pinch them when installing them.Use curil K2 good German goop.

1303Steve Scirocco Rare

8,650 posts · joined Aug 2002 · 21 Jul 2004, 9:46 pm

#205938

Hi

I always used rubber grease on them as they are supposed to move in & out as the motor expands and I polished the bores that they slide in with 1200 wet & dry.

1302Steve