Skip to content
Aussieveedubbers

Type 3 engine into beetle?

0 likes
Share Share on Facebook Share on X Share on Reddit

Rota_Motor

Former member ·

#210809
hi people, havent been on for a wghile, but Danielle is still around 😉

anyways, as the title says, if we pick up a complete engine out of a type 3, will it fit into the beetle, obviously after converting to the upright/porsche type cooling fan setup?

just thinking it will be easier to pick up a type 3 engine complete with twinport heads and twin carbs, and shove it all into the beetle together, rather han changing heads, then carbs onto the current short block, which needs to have the cooling system checked out anyway.

thanks for any help 🙂

PS, I guess this is really just asking if the Type 3 block and barrels will fit, as I've already asked about the carbs and heads before 🙂

lulu94 Wolfsburg Wizard

449 posts · joined Dec 2003 ·

#211052
cheers cray

Danielle
1968 pearl white beetle:kiss
1600 engine😉
soon to be supercharged 🤘🤘

1970 and 72 Squarebacks 70 soon to be rotor powered

lulu94 Wolfsburg Wizard

449 posts · joined Dec 2003 ·

#211055
hey cray was it easy to do, any tips you have or anything we need to remember.

at least i know it can be done

Cheers Danielle (on ryans behalf )
1968 pearl white beetle:kiss
1600 engine😉
soon to be supercharged 🤘🤘

1970 and 72 Squarebacks 70 soon to be rotor powered

cray Wolfsburg Wizard

462 posts · joined Aug 2002 ·

#211408
my dad did most of the work, but the only thing i remember that needed to be done other than the completely obvious in regards to the fan housing and whatnot, was tapping a new oil filler hole

lulu94 Wolfsburg Wizard

449 posts · joined Dec 2003 ·

#214306
anyone else have any hints or tips that we should know about before we start this.

Cheers Danielle
1968 pearl white beetle:kiss
1600 engine😉
soon to be supercharged 🤘🤘

1970 and 72 Squarebacks 70 soon to be rotor powered

Secoh Fahrvergnugen

926 posts · joined Sep 2002 ·

#214647
I've just finished this, so far I have found I had to:

Fit all the type 1 tin ware and oil cooler,
Drill and tap a new oil pressure switch hole,
Make a blanking plate where the type 3 dipstick and oil fill tube bolts to the sump,
Make a new dipstick tube to fit to said blaning plate. I tried to drill the dipstick hole in the block same as beetle but I didnt have a drill bit long enough and gave up on that idea.

I'm using the type 3 twin carbs and had to make the linkage brackets too, but if you use the stock beetle carb and manifold then no problem.
If it aint broke,
Make it go faster!!

lulu94 Wolfsburg Wizard

449 posts · joined Dec 2003 ·

#214822
thanks for that secoh is a big help.

Danielle
1968 pearl white beetle:kiss
1600 engine😉
soon to be supercharged 🤘🤘

1970 and 72 Squarebacks 70 soon to be rotor powered