Skip to content
Aussieveedubbers

Noisy Clutch

1 like
Share Share on Facebook Share on X Share on Reddit
Log in to reply

Dozza Officially Full-On Dubber

318 posts · joined Dec 2004 ·

#404672
Just put an engine back together.....

Had the clutch off - all looked fine....

Now, she is driving well but with a noisy clutch operation when fully pressed down.... what have I done wrong??

I am expecting to have to take the engine out, but would mind some head start advice if anyone has any!!

Its a sort of slipping grindy noise, not real bad. Changes gear fine

All advice appriciated

Thanks


Dozza - the eternal kombi problem king......


btw

Sorted the backfiring engine out.... was the plugs... duh they were knackered. Initially I thought they looked ok..... THe carb was in need of a tune too
Thanks for all advicenn[ Edited on 6-9-2005 by Dozza ]
Low Slow and Cruising

Bizarre Moderator The artist formerly known as blue74l

12,789 posts · joined Aug 2002 ·

#404695
as Dave said with the thrust race bearing.

it sort of "sits" in the forks. It may have been knocked a tad and is not sitting right.
It only presses against the plate whan the pedal is engaged.

Either that or some of the "fingers" on the pressure plate are stuffed.
Futue te ipsum!!!

General_Failure Use your head, don't abuse it!

1,036 posts · joined Jun 2004 ·

#404710
Contamination can also get into the thrust race and make a bit of a mess of things too. Can make things noisy.
If at first you don't succeed. Build, build again.
Vehicle: 1975 Special order delivery walkthrough panel based LCA pop-top camper. Motor: Nippon 1.8L Single port Wasserboxer, Transmission: 3 rib 002.