no I was being a smart arse....looked at it, had previous experience with Pugs in a former life, - down here the motors are rare and expensive, they should fit in the engine bay, from my measuring. The rad/plumbing as per
www.customoffroad.com.au - in the chassis rails. In fact the conversion would be very similar, just get Pug bits not Sube - they seem to be dirt cheap in the UK. Not sure what you're looking at, I was looking at IRS bus with single side place Lbug box. You can get the adaptor plate made up easy enough....it's the Pugs kick arse torgue curve I wanted, not the out and out 'at the wheels'. Still a good idea....AU just lacks parts.
Also thought the Renault 19 16v motor would do a similar job.
My appologies once again for being a smart arse.
