Kadron Problems

RENNWAGEN Seriously Crusin Dubber

158 posts · joined Sep 2003 · 3 Jan 2006, 5:12 pm

#443535

I am having problems with my kadron carburettors or one of them to be precise.I have recently had them cleaned as the car was sitting for a while and there was a bit of varnish build up the carb guy also replaced both float valves and one float.I put them in the car adjusted the idle and they ran fine for a couple of weeks. Last week i was driving and the bus started to hesitate running on three and then two cylinders. The right side carb was flowing way too much fuel the plugs had oiled and ceased to fire. float valve is free and seems to operate ok dropped in a new set of plugs and it ran for about a km before they stopped firing again idle adjust screw has no effect. I am running an electric fuel pump that I have run for years without problems. Any ideas?

shiftyvw Wolfsburg Wizard

523 posts · joined Sep 2002 · 3 Jan 2006, 5:48 pm

#443545

if you have an electric fuel pump, switch the ignition on so the pump is running but the engine isnt, and have a look down both carbs to see if the side your having problems with is drizzling fuel into the engine, if it is replace the needle and seat.

testing 1 2 3...

RENNWAGEN Seriously Crusin Dubber

158 posts · joined Sep 2003 · 3 Jan 2006, 7:13 pm

#443576

Needle and seat is the float valve or something else? Iturned on the fuel pump and it started to trickle, kept going after I had turned it off. I hadnt noticed this before as its in a bus and you cant get your head in there had to use a mirror and a light, the float valve is notstuck but I was thinking maybe an extra washer or two might help it get a more positive shut off?

Bizarre Moderator The artist formerly known as blue74l

12,789 posts · joined Aug 2002 · 3 Jan 2006, 8:14 pm

#443604

Sounds like needle and seat (float valve)

Try reading hear - AJ Simms site. Lots of Kadron help here

http://www.lowbugget.com/

Futue te ipsum!!!

jakjones Officially Full-On Dubber

217 posts · joined Mar 2004 · 3 Jan 2006, 9:52 pm

#443658

maybe the needle valve has come loose ?

or is internally blocked , replace it again.

RENNWAGEN Seriously Crusin Dubber

158 posts · joined Sep 2003 · 7 Jan 2006, 9:24 pm

#445051

Thanks guys found the problem my new float was a sink.