Tension on front wheel bearings

783 posts · joined Jan 2005 · 14 Jan 2006, 7:39 pm

#447092

how do you get the tension on the front wheel bearings to be right, is it best to tighten them up so they're tight and loosen a bit a 1/4 of a turn?
thanks guys :thumb

🙂

jnr356 Wolfsburg Wizard

603 posts · joined Jan 2004 · 14 Jan 2006, 11:33 pm

#447140

you should be able to move the washer behind the nut so that it has a very slight amount of drag(this is done using a screw driver,being careful not to damage the bearing cage)
wheel bearings are not something to be messed with and they should be packed with grease correctly, with the correct grease.
i've seen an overtightened wheel bearing sheer the stub axle right off!

vw54 Administrator Always Waiting 4 Friday

16,723 posts · joined Aug 2002 · 15 Jan 2006, 9:39 am

#447186

Also spin the wheel while your tightening the nuts so as to center the bearing as per above

Packing the bearing with the correct grease and doing the packing correct is most important

also over tightening will damage the bearing and creat drag on the wheel

I read it on FACEBOOK so it must be true

http://forums.aussieveedubbers.com/viewtopic.php?tid=91278&page=1#pid848630

http://forums.aussieveedubbers.com/viewtopic.php?tid=63561&page=1#pid624099

http://forums.aussieveedubbers.com/viewtopic.php?tid=4832&page=1#pid452603

http://forums.aussieveedubbers.com/viewtopic.php?tid=60650&page=1#pid574409