I will be putting some in in a couple of weeks. If you can wait that long I will take some pics. But a brief set of instuctions is to:
1) mark where the position of each grub screw is in the middle section you cut out on a section you dont cut out so you can align the new adjusters.
2) cut out the middle section of one torsion tube, cutting out the same width as the new adjuster which is to be welded in. Only do one tube at a time so it stays aligned etc. You could also weld a bit of flatbar or angle across the section you cut out and leave it in there until the new section is welded in.
3) Chamfer the edges of the cut so the weld goes all the way through
4) Depending on what brand and how high/low you want to go determines what angle you put the enw adjuster. If you want to make the middle of the adjustment standard height for example, you would weld the new adjuster in so that the middle of the adjustment is the same angle as the original grub screw on the bit that came out. But be careful, the external screw on the new adjuster might not be the same as the one that holds the torsion leaves in, it might be at 90degress or whatever like my previous ones were.
Sharbuilt Beach buggy with Subaru 2L Turbo
Thunderanch Riot with Subaru 2L Turbo
Manxter with FA20turbo
Click here for wiring looms
