carbi tune prob;any suggestion?

lohoon Wolfsburg Wizard

466 posts · joined Sep 2002 · 2 Dec 2007, 8:04 pm

#623228

Hey all,
I am running twin kads on a 1600.
its favouring clys 1&2 .U can hardly notice when i pull 3or4 plug leads off.
the inlet manifold for 3&4 is very cold.I'm guessing the float level may need adjusting.Does anyone know where i can get a diagram to show how to set the float level?
cheers
scott

greedy53 Bishop of Volkswagenism

3,062 posts · joined Mar 2006 · 2 Dec 2007, 8:50 pm

#623236

give vintage vw at campsi nsw a call if they cant help no one can and they will tell over the phone

👍👍😂🙅🥷😬🤓

matberry Moderator Go hard or go home

8,114 posts · joined Mar 2006 · 2 Dec 2007, 9:46 pm

#623247

Check carb balance. Increase idle speed on 3/4, and decrease on 1/2, untill same idle speed drop on all cylinders, then reset linkage balance very carefully so both carbs start opening off idle at EXACTLY the same time.

Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE

Bizarre Moderator The artist formerly known as blue74l

12,789 posts · joined Aug 2002 · 2 Dec 2007, 9:52 pm

#623249

lots of Kad info here

http://www.lowbugget.com/help_section.html

Futue te ipsum!!!

13bwagon Officially Full-On Dubber

316 posts · joined Nov 2006 · 3 Dec 2007, 7:23 pm

#623393

make sure the valves are not over tight

BUY A REAL BUG A PRE S BUG...

lohoon Wolfsburg Wizard

466 posts · joined Sep 2002 · 3 Dec 2007, 10:18 pm

#623430

Thanks for your suggestions.Will have a fiddle and see what we can sort out.