Posts: 63
Threads: 18
Registered: April 24th, 2014
Member Is Offline
Location: Coffs Harbour
Theme: UltimaBB Pro Blue ( Default )
posted on August 28th, 2014 at 03:14 PM
Installing tinware
So I'm gonna sound like an idiot but while making my 2ltr engine look good before I install it I took all the tinware off and replaced the pieces
that were stuffed and painted it all up to look good. To two big pieces that go over the main section of the engine aren't going in properly, it
needs to go an inch further forward so it can sit right down. Just making sure there's no trickles to it before I hack at it with an angle grinder.
Is it possible I've got pieces for the wrong engine? is there any differences in tinware?
Cheers
Waterz95
Commited Dubber
Posts: 63
Threads: 18
Registered: April 24th, 2014
Member Is Offline
Location: Coffs Harbour
Theme: UltimaBB Pro Blue ( Default )
posted on August 28th, 2014 at 03:59 PM
Okay well I worked our the issue there's two big heads sticking out next to where the carbi manifolds come out, a very slight modification and
problem solved.
