| [ Total Views: 568 | Total Replies: 4 | Thread Id: 107461 ] |
|
|
 gazzac
Seriously Crusin Dubber
Posts: 122
Threads: 42
Registered: December 28th, 2009
Member Is Offline
Location: Surrey Downs Adelaide SA
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 22nd, 2014 at 08:39 PM |
|
|
1500 beetle engine.
Ok, I have a 66 beetle and a 1500 engine. The motor needs to be rebuilt, my question is, what would be the best set up for it. What cam, pot and
pitons, what push rods tubes and lifters, carbs, dizzy, looking at doing all the work myself and would be helpful to know what others have done or
used.
gulf blue1966 Beetle,1500 manual.
|
|
|
LUFTMEISTER
Veteran Volks Folk
Posts: 2041
Threads: 119
Registered: July 13th, 2005
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
Mood: BRISVEGAS in a state of flux
|
| posted on October 22nd, 2014 at 08:47 PM |
|
|
First you need to pull down your engine to see if it is indeed rebuildable. With the age of these motors it could have a crack in the block or end
float problems that may make the motor u/s. Then you can form a plan of attack. My2c
Customer service is not dead in Australia.
Always after HAZET & MATRA & VW factory tools
|
|
|
 Bizarre
Super Moderator
The artist formerly known as blue74l
Posts: 12757
Threads: 732
Registered: August 25th, 2002
Member Is Offline
Location: Abbotsford, Sydney
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 22nd, 2014 at 08:58 PM |
|
|
do you definitely want to stay single port?
Futue te ipsum!!!
|
|
|
gazzac
Seriously Crusin Dubber
Posts: 122
Threads: 42
Registered: December 28th, 2009
Member Is Offline
Location: Surrey Downs Adelaide SA
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 23rd, 2014 at 12:45 PM |
|
|
I would like to go twin port, twin carbs. The block is good, very little end float. Motor ran sweet before I pulled it out. No unusual noises rattles
or bangs. No oil leaks either.
gulf blue1966 Beetle,1500 manual.
|
|
|
fish26
A.k.a.: benito
Fahrvergnugen
Posts: 903
Threads: 38
Registered: July 13th, 2007
Member Is Offline
Location: sydney
Theme: UltimaBB Pro Grey
Mood: Ken awesome
|
| posted on October 23rd, 2014 at 01:37 PM |
|
|
1679cc 8.0:1 comp
Stock crank checked, balanced
Stock rods checked, balanced new nuts
All new bearings Silverline
Seal kit
Case kit
Engle 110 cam
Engle lifters
Scat pushrod tubes
Stock pushrods new cut to correct length
Stock rockers w/swivel feet on H/D shaft
88mm AA p/c kit slip into case machine heads
Heads stock valve machined for 88mm single H/D springs
Oil pump IN/OUT full flow
36DRLA or 40IDF twins on matchported manifolds
Vintage speed exhaust
have fun
ben
bitten by the bug..........several times
|
|
|
