Posts: 5
Threads: 2
Registered: May 30th, 2013
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on May 7th, 2016 at 08:02 PM
Pedals
Hi guys
Could someone please tell me how the pedal assembly comes out of my country buggy floor pan.
The assembly is very rusty and I'm struggling to see where the 2 sides seperate to remove from the tunnel.
Thanks Paul
bevoracing
A.k.a.: Tony Beven
Officially Full-On Dubber
Posts: 326
Threads: 36
Registered: January 18th, 2009
Member Is Offline
Location: Mount Pleasant SA
Theme: UltimaBB Vintage
Mood: Leaning against the shed wall !.
posted on May 8th, 2016 at 08:12 AM
Hi Paul
They can be a bit tricky with a lot of rust.
There is a bracket on the right, near the accelerator, with bolts through the plate on the floor pan.
The plate with the 2 bolts on the right hand side of the floor pan is just a support. Remove the bolts and the plate lifts up and out.
The plate with the 2 bolts on the left hand side of the floor pan is a bush with a circlip on the outside. Take the bolts out, remove the circlip and
the lever, it just “slips” off the accelerator shaft (in your dreams) heat it with the oxy. Then the support plate slides off.
In these pictures it’s a CB pedal but not a CB chassis. You’ll get the idea. Sorry, no picture of the left hand side.
Good luck, don’t force it.
Cheers
Tony
Error
Sorry, you must be a registered user in order to download attachments.
Error
Sorry, you must be a registered user in order to download attachments.
Error
Sorry, you must be a registered user in order to download attachments.
