Posts: 78
Threads: 7
Registered: February 3rd, 2011
Member Is Offline
Theme: UltimaBB Pro Grey
posted on April 4th, 2019 at 08:23 PM
Temperature gauge not working
Hey guys
I've just swapped my ej22 that I'd ran for 3years for an ej25.
The swap has gone well, but I had to replace the original harness with ej25 one.
My problem is that I've connected the aftermarket gauge to the temp wire and I'm getting nothing at the gauge. With the previous harness I just
connected straight up to the wire and it worked. Did the ej25 have some kind of resistor somewhere or what?
Any help appreciated.
Cheers John
1303Steve
A.k.a.: Steve Carter
Scirocco Rare
Posts: 8636
Threads: 559
Registered: August 27th, 2002
Member Is Offline
Location: Sydney, NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Parrot Heading
posted on April 5th, 2019 at 07:25 AM
I drilled and taped the water log and used a VDO sender with my VDO gauge. Not sure if they use different senders in later motors but I think it could
be risky trying use an aftermarket gauge with a factory sender. Can you unscrew the factory sender and fit the correct sender for your gauge?
