Posts: 117
Threads: 19
Registered: July 26th, 2004
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on May 20th, 2005 at 02:16 PM
busbeam
hey guys
Im just about to weld adjusters in my bay beam, so it off and in bits and i was wondering if its worth narrowing it now while its off. because i
intend to build some dropped spindles in the future. But does narrowing screw round with roadworthy cert, im guessin u have to get engineers
reports.Also with the adjusters in the indian intructions they say to wack the centre leaf holder out with a pipe where as else where ive read they
say u should remove the strearing link and drill out the spot weld Is this needed ? does the spot weld ever bake dodgy with the Indian way?
cheers (sorry about the essay)
57kombi
Son of Jim - Creator of Good
Hannover Elder
Posts: 2544
Threads: 181
Registered: August 27th, 2002
Member Is Offline
Location: adelaide
Theme: UltimaBB Pro Blue ( Default )
Mood: Got one, but keeping it under wraps
posted on May 20th, 2005 at 02:28 PM
I think that you will find that even fitting adjusters you will need an engineers certificate as you are modifiying it, And the quality of the weld is
very important.
So I would narrow it at the same time, saves one visit to the engineers.
Cheers
Dave
Marz
Seriously Crusin Dubber
Posts: 117
Threads: 19
Registered: July 26th, 2004
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
posted on May 21st, 2005 at 01:18 PM
Im thinking that i might narrow different beam that i have as i wanna get this project goin asap. anyone know any good sites that have how too's on
narrowing beams?
