Posts: 1991
Threads: 309
Registered: August 26th, 2002
Member Is Offline
Location: South Coast NSW
Theme: UltimaBB Pro Blue ( Default )
posted on September 5th, 2002 at 07:48 PM
T4 engine removal
Simon,
I have always removed the two top tranny bolts, then lowered the engine and gear box about 4 inches, put a jack stand under the gear box then split
the engine from the box, and lower the engine down, leaving the box on the jack stand.
It won't clear the back of the car with out a lot if juggling if you don't lower the gearbox a bit.
This was a reply to Simon Glenn's post but I stuffed up and started another one
[Edited on 5-9-2002 by Dave Becker]
paulr
Officially Full-On Dubber
Posts: 332
Threads: 103
Registered: August 29th, 2002
Member Is Offline
Location: Melbourne (Brunswick)
Theme: UltimaBB Pro Blue ( Default )
posted on September 9th, 2002 at 08:38 PM
Well guys I reckon i must have missed something but It can be done and will be done again shortly without touching the gearbox mounts
Dazed and Confused
and riding a pushi
KruizinKombi
A.k.a.: Col
Bishop of Volkswagenism
Seriously Obsessed Cyber Dubber
Posts: 3493
Threads: 104
Registered: August 25th, 2002
Member Is Offline
Location: Gippsland, Victoria
Theme: UltimaBB Pro Blue ( Default )
Mood: Indifferent