| [ Total Views: 684 | Total Replies: 6 | Thread Id: 91354 ] |
|
|
 stagvee40
Commited Dubber
Posts: 68
Threads: 14
Registered: January 20th, 2011
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
 posted on July 2nd, 2011 at 12:01 PM |
|
|
Gearbox oil amount
Hi,
I pulled the axle boots of my gearbox the other day to find the left side was holding about 300mls of oil in it and the right one just had a little in
the bottom. should there be any in there? Perhaps I am using to much gearbox oil how much do you guys use?
any help would be much appreciated.
|
|
|
68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline
Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -
|
 posted on July 2nd, 2011 at 12:52 PM |
|
|
[size=4]Hi
about 3 litres of 90 HYPOID gearbox oil
or 75/80 or 75/90 HYPOID oil
You fill it thru the side filler hole...
pour it in slowly as if it is poured in too fast it will overflow and You will think its full..
the oil will flow out to the axles and outer bearings..
its a tricky job pouring the oil in thru the filler hole... lol
best to drain the oil thru the bottom drain hole so You will have ALL new oil...
cheers
LEE
[/size]
- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
|
|
|
Joel
Scirocco Rare
Now containing 100% E-Wang
Posts: 9368
Threads: 211
Registered: February 14th, 2006
Member Is Offline
Location: Northern Rivers NSW
Theme: UltimaBB Pro Purple
Mood: Tact Level 0.00
|
| posted on July 2nd, 2011 at 01:12 PM |
|
|
They take 2.5L but it's hard with swing axles as some flows down the axle tubes to the wheel bearings so the actual amount is usually abit more.
But all you do is fill it till its up to the bottom of the filler plug if the car is reasonably level.
If you're gonna drain it though make sure the filler plug on the side unscrews first.
Lots of people have got caught out draining their oil then finding out the filler plug is seized up or rounded out.
You're pretty right with an F-Vee but in a car it makes life so much easier to just get a little hand pump to fill them rather than trying to pour
into a sideways funnel.
|
|
|
HappyDaze
A.k.a.: Greg Mackie
Son of Jim - Creator of Good
Superannuated
Posts: 2887
Threads: 141
Registered: June 13th, 2009
Member Is Offline
Location: Southern Highlands NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: Happy enough
|
| posted on July 2nd, 2011 at 04:23 PM |
|
|
As Joel says.
Not sure what the go is these days, but I used ATF in my Vee trans., with a dash of Moly for the crown wheel & pinion.
300ml seems a lot for a boot to hold.......maybe you should find a circuit with more left-hand corners.
I'd rather wear a Beetle out by racing it than by polishing it!
|
|
|
stagvee40
Commited Dubber
Posts: 68
Threads: 14
Registered: January 20th, 2011
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 2nd, 2011 at 10:19 PM |
|
|
Thanks guys, I will fill it to the bottom of the plug, seal up the boot with some gasket cement and see how she goes!
|
|
|
68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline
Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -
|
| posted on July 3rd, 2011 at 12:29 PM |
|
|
the boots are joined at about 45 degrees or more
but NOT at the top as there is too much flex at the top..
LEE
- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
|
|
|
stagvee40
Commited Dubber
Posts: 68
Threads: 14
Registered: January 20th, 2011
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on July 4th, 2011 at 10:30 AM |
|
|
thanks, thats does make sense, will do.
|
|
|
