| [ Total Views: 902 | Total Replies: 14 | Thread Id: 92705 ] |
|
|
 clyve
Officially Full-On Dubber
Posts: 310
Threads: 93
Registered: February 19th, 2011
Member Is Offline
Location: sunshine coast
Theme: UltimaBB Pro Blue ( Default )
Mood: painfully happy
|
 posted on September 17th, 2011 at 02:16 PM |
|
|
SUNSHINE COAST QLD: help please!!!!!!!!!!!!!!!im going mad
can anybody help please????
I have a 1600 twin port with new carby new 009 dizzy the engine has had a top end rebuild by goldy VW and I still can't get it to run properly.
I have new seals on the manifold and new gaskets through out the car.
It starts ok on choke but after a minuite of idling then she misses splutters and eventualy dies.
I have followed the Haynes manuel and still no go.
is there anybody local(sunshine coast) or has a brain wave that will help this new bug man.
many thanks
|
|
|
Ollie
A.k.a.: Ollie Clarke
Insano Dub Head
Yeah Buddy
Posts: 840
Threads: 122
Registered: October 5th, 2009
Member Is Offline
Location: Sydney
Theme: UltimaBB Streamlined2
Mood: Hungry for another 676cc
|
| posted on September 17th, 2011 at 02:23 PM |
|
|
Sounds like jetting issues possibly? Have you checked the idle screw?
|
|
|
Ollie
A.k.a.: Ollie Clarke
Insano Dub Head
Yeah Buddy
Posts: 840
Threads: 122
Registered: October 5th, 2009
Member Is Offline
Location: Sydney
Theme: UltimaBB Streamlined2
Mood: Hungry for another 676cc
|
| posted on September 17th, 2011 at 02:23 PM |
|
|
*idle jet and mixture screw?
|
|
|
vwjon
Fahrvergnugen
Posts: 914
Threads: 101
Registered: July 16th, 2006
Member Is Offline
Location: perth W.A
Theme: UltimaBB Pro Blue ( Default )
Mood: oily n thirsty
|
| posted on September 17th, 2011 at 02:28 PM |
|
|
remove and block off all vacuum hoses etc, you could be sucking air in somewhere. are all the tubes on the carby blocked off properly?
3 1959 cadillacs
1 musso
2 early notchbacks
2 split kombis
2 split panels
1 split ute
1 low light panel
1 ex-pmg bay
1 country buggy
1 beetle ute
1 14" syncro caravelle
1 16" syncro doka
1 golf cabrio
1 vw camper trailer
2 3meter bombs
|
|
|
68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline
Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -
|
 posted on September 17th, 2011 at 02:32 PM |
|
|
HELP SUNSHINE COAST DUBBER TUNE HIS CARBY
Have You checked out the automatic choke??
after a few minutes it should be wide open
take the air cleaner off and look down the throat of the carby
the choke flap will be closed when the engine is cold...
once it running the choke flap should open up allowing the engine to idle at a slower rpm..
also check to see that fuel sprays into the throat of the carby every time You press the throttle down..
this is the accelerator pump working...
without it... You cannot drive a car... not enough power..
You can check that with the engine not running...
there is a diaphram in the accelerator pump and also a ball valve that can get stuck stopping the accelerator pump from getting fuel..
Are the points at the right gap?
there are some 009 dizzies that You cannot time.... chinese
plus ALL 009s should be timed at revs at around 28 to 32 degrees BTDC
and the idle timing is whatever it is when idling..
You don't time a 009 at idle...
also check out ; http://www.vw-resource.com/
and see if there is any info on there You haven't checked..
would be good if a local can check Your car for You...
even mechanics have lots of problems with beetle engines as late model cars don't have carbies or points etc...
cheers
LEE
- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
|
|
|
Anthiron
A.k.a.: Nicko McKay
Compulsive Aussie Vee Dubber
The Baja Rejuvenation Begins
Posts: 4936
Threads: 310
Registered: October 1st, 2003
Member Is Offline
Location: Buderim QLD
Theme: UltimaBB Pro Blue ( Default )
Mood: Hell hath no fury like a womans scorn for sega.
|
| posted on September 17th, 2011 at 02:36 PM |
|
|
Where are you? Does the car drive? What carby? I'm in Buderim. Would be happy to have a look.
62/60 model bug eye baja bug, (Full Build in Progress)
1974 Chevrolet Luv
1970 MK2 Ford Cortina GT
1979 Yamaha RX125 Two Stroke tracker project.
2004 Harley Davidson Sportster XL Custom
|
|
|
68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline
Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -
|
 posted on September 17th, 2011 at 02:38 PM |
|
|
again looking down the throat of the carby...
engine going..
when the engine stops idling and starts to misfire
check that the needle and seat in the carby are not shutting the fuel off when the carby bowl is full which would result in the fuel over flowing down
into the throat of the carby
and choking the engine....
too much fuel... not enough air...
You can check by disconnecting the fuel line into the carby...
and starting the engine ...
if it runs OK and then idles ok...
chances are its a flooding problem...
cheers
LEE
- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
|
|
|
 MISS VDUB
A.k.a.: Ash
Super Administrator
Mrs KOMBIBOB
Posts: 2565
Threads: 96
Registered: September 20th, 2005
Member Is Offline
Location: Beautiful Sunshine Coast, QLD
Theme: UltimaBB Pro White
Mood: Low down and Dirty
|
| posted on September 17th, 2011 at 02:58 PM |
|
|
Hi Clyve, i HIGHLY recommend you give Matt a call. Matt is a Volkswagen specialist and great guy!
Matt Berry Motor Sports
5 Old Coach Way, Lake Macdonald Qld 4563
Contact: Matt Berry
Phone: 07 5472 0212
Email: mattberrymotorsports@y7mail.com
Tell him Ash and Bob sent you! 
1963 Single Cab Ute: "El Concreto"
1962 Baja Beetle: "Peanut"
1968 Porsche 912 SWB: "Pip"
1972 Kombi Snail: "The Snail"
2012 Skoda Octavia Scout: "Scout"
2016 Scirocco R: "Rocco"
|
|
|
h
A.k.a.: Towely BuMpEr KING! ILLegal ALIEN on a roadtrip
Scirocco Rare
fractals - an ever changing lifestyle
Posts: 7670
Threads: 375
Registered: February 3rd, 2005
Member Is Offline
Location: noosa hillbilly 'yee har'
Theme: XMBX Pro Green
Mood: A T3 is not a Kombi - stop waving at me
|
| posted on September 17th, 2011 at 08:45 PM |
|
|
go n see matt he's local
|
|
|
OZ Towdster
A.k.a.: Andrew Westwood
Custom Title Time!
Keen to finish some projects
Posts: 1921
Threads: 132
Registered: December 7th, 2003
Member Is Offline
Location: Alexandra Hills Brisbane QLD
Theme: UltimaBB Pro Yellow
Mood: Having fun in our great land
|
| posted on September 17th, 2011 at 08:59 PM |
|
|
As others have said , best you give matt a ring , but my guess for you problem is either you have idle mixture screw adjustment problem OR due to the
top end rebuild and the slight narrowing of the motor from head to head inlet ports then your centre section of your 3 piece manifold may need cutting
down by 3 or so millimetres so as to enable your inlet maniold cast ends to sit flat to the inlet face on the heads and not be forced out by the to
long centre section .
Hope this makes sence , but again talk to Matt and or Jack @ GCVD
Don't let body work get in the way of real suspension travel
|
|
|
clinker42
Officially Full-On Dubber
Posts: 381
Threads: 154
Registered: August 19th, 2008
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on September 17th, 2011 at 09:34 PM |
|
|
If thats the brosol carb, i had the same issues. Pulled it apart and stuffed around for ages, then blocked the hole in the throttle blade and it
worked a charm after that.
|
|
|
 matberry
Super Moderator
Go hard or go home
Posts: 8114
Threads: 134
Registered: March 7th, 2006
Member Is Offline
Location: Cooroy Qld
Theme: UltimaBB Pro Blue
Mood: enjoying waving at all my Kombi buddies from my T3
|
| posted on September 18th, 2011 at 09:27 AM |
|
|
Clyve, as others have kindly suggested, give me a call to walk you through it or depending on where you are I could come check it out for you. I will
be out and about today Sunday, so call asap, if you wish.
Matt Berry Motorsports...air cooled advice, repairs and mods Ph 0408 704 662
OFF-ROAD,CIRCUIT,DRAG,STREET,ENDURANCE
 |
|
|
clyve
Officially Full-On Dubber
Posts: 310
Threads: 93
Registered: February 19th, 2011
Member Is Offline
Location: sunshine coast
Theme: UltimaBB Pro Blue ( Default )
Mood: painfully happy
|
| posted on September 23rd, 2011 at 04:39 PM |
|
|
thanks
big thanks to all who helped, managed to get her up to matthew at motor sports and the guy is a genius.....
If you are new to this like me get on the phone as these blokes have forgoten more than I will ever know.
thanks agin to all that helped.
|
|
|
Anthiron
A.k.a.: Nicko McKay
Compulsive Aussie Vee Dubber
The Baja Rejuvenation Begins
Posts: 4936
Threads: 310
Registered: October 1st, 2003
Member Is Offline
Location: Buderim QLD
Theme: UltimaBB Pro Blue ( Default )
Mood: Hell hath no fury like a womans scorn for sega.
|
| posted on September 23rd, 2011 at 04:56 PM |
|
|
So what was the problem?
62/60 model bug eye baja bug, (Full Build in Progress)
1974 Chevrolet Luv
1970 MK2 Ford Cortina GT
1979 Yamaha RX125 Two Stroke tracker project.
2004 Harley Davidson Sportster XL Custom
|
|
|
clyve
Officially Full-On Dubber
Posts: 310
Threads: 93
Registered: February 19th, 2011
Member Is Offline
Location: sunshine coast
Theme: UltimaBB Pro Blue ( Default )
Mood: painfully happy
|
| posted on September 23rd, 2011 at 05:11 PM |
|
|
dizzy
couldn't get the eng to tune and sucking air on the carby, going back to a vacuum advance. DOHH!
|
|
|
