| [ Total Views: 767 | Total Replies: 9 | Thread Id: 107473 ] |
|
|
 grogy
Custom Title Time!
Posts: 1000
Threads: 344
Registered: August 16th, 2007
Member Is Offline
Location: Gold Coast
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 24th, 2014 at 08:26 PM |
|
|
draw thru
hi, ca u have a drawthru turbo set up with the carb up top in roundabout the standard place and the turbo down under the apron. any ideas? thanks
|
|
|
nils
Fahrvergnugen
Posts: 971
Threads: 65
Registered: January 11th, 2008
Member Is Offline
Location: central coast
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 25th, 2014 at 06:47 AM |
|
|
I think the problem you will run into is the up and down nature of your plumbing after shut down you will have pooling at the lowest point resulting
in start up trouble.
I made this mistake in a kombi years ago, having to carry a small blow torch to heat the low area to enable starting when cold.
Rayjay also ran into this problem with there kits (had one of those too) having a petcock at the low point so you can drain the pooling.
After messing with carbs for awhile I changed to injection and I can tell you for a road car injection is the way to go if you have your heart set on
a turbo
Quit calling rust patina
|
|
|
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
|
| posted on October 25th, 2014 at 09:28 PM |
|
|
Try looking for a Renault 5 Turbo carb, turbo and fuel pump. Been used quite successfully on less than 1700 VW flat4s 
It's a pressure sealed carb so all you need do is plumb up from the turbo to the carb 
Bit searching using Google UK should find you the bits you need as don't think the R5T was a popular option in Oz.
madness is in the eye of the beholder  |
|
|
grogy
Custom Title Time!
Posts: 1000
Threads: 344
Registered: August 16th, 2007
Member Is Offline
Location: Gold Coast
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 26th, 2014 at 10:59 PM |
|
|
hi, thanks for your thoughts and ideas. if i did go turbo it would be a 2387cc so i dont think the renault set up is suitable. i like the simplicity
of the draw thru carb set up , but it seems not such a great idea having the turbo inside near the alternator. especially in qld. the injection is a
good idea except for the costs, and after its all set up its more costs in getting it tuned. and im not that savy with comps and doing it myself.
stuck between a rock and a hard place and not sure of any other options. but i do like the idea of a turbo. if you have any more input , please do.
thanks greg
|
|
|
psimitar
Son of Jim - Creator of Good
Posts: 2506
Threads: 148
Registered: January 1st, 2009
Member Is Offline
Location: North East Melbourne, VIC
Theme: UltimaBB Psyche Blue
|
| posted on October 27th, 2014 at 12:49 AM |
|
|
Ask Vlad on here about delco engine management. He says it's very cheap n plenty of support.
most rolling roads seem to only like playing with certain expensive aftermarket stuff it seems. Poor show really.
madness is in the eye of the beholder |
|
|
ian.mezz
Wolfsburg Elder
I never said, I could write or spell
Posts: 3913
Threads: 280
Registered: September 11th, 2004
Member Is Offline
Location: Newcastle
Theme: UltimaBB Pro Blue ( Default )
Mood: Happy
|
| posted on October 27th, 2014 at 07:36 PM |
|
|
http://www.turbosmartusa.com/news/air-cooled-warrior-2
ask VW USA Sponsored Car Karmann Ghia Brenden Mosher
The little red menace you see here belongs to the Turbosmart USA Sales Manager – Brenden Mosher
|
|
|
grogy
Custom Title Time!
Posts: 1000
Threads: 344
Registered: August 16th, 2007
Member Is Offline
Location: Gold Coast
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 27th, 2014 at 09:09 PM |
|
|
hi ian, i like the simplicity of the setup, but how would u keep it cool enough to be a streeter with that turbo inside the compartment. i asked that
question on the link. hopefully i get an answer
|
|
|
coletrickle
Wolfsburg Wizard
Posts: 661
Threads: 34
Registered: April 22nd, 2009
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 27th, 2014 at 10:07 PM |
|
|
I thiink another very important question that is never asked and should be the first one asked is how much gearbox can i afford from dave
buttler?Cause if ya ain't spending a serious bit of coin on a box your wasting your time.As for your post oil drain back may be an issue.As for the
renault carb don't assume cause it's off a 1700 and you want to put it on a 2300 plus cc vw it's to small,those renauls can see an honest 250hp so
it'll only be a problem if you plan on making more than 250hp.Oh an e85 you'll be running real cool!
|
|
|
grogy
Custom Title Time!
Posts: 1000
Threads: 344
Registered: August 16th, 2007
Member Is Offline
Location: Gold Coast
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 29th, 2014 at 07:25 PM |
|
|
hi col, i already got trans that handle it easy, ratios a bit short, so just need stickty tyres. and dave can do them in his sleep, he only charges
half as much when he is sleeping. i like more than 250 otherwise may as well stay naturally aspirated. so u reckon even with the turbo in the engine
bay e85 will keep it cool enough to be a reasonable streeter. thanks greg
|
|
|
coletrickle
Wolfsburg Wizard
Posts: 661
Threads: 34
Registered: April 22nd, 2009
Member Is Offline
Theme: UltimaBB Pro Blue ( Default )
|
| posted on October 29th, 2014 at 10:09 PM |
|
|
just a thought have you looked at a vortec supercharger it a bit old school but it may be what you need if you want decklid shut no heat streeter.The
vortec is the intake side of a turbo with a gearbox where the exhaust housing would be and belt driven,and on e85 you could run quite a lot of boost
and not need an intercooler.
|
|
|
