Board Logo
Go To Bottom

Forum Rules
Effective 14/01/2014, the forum rules are here:

http://forums.aussieveedubbers.com/viewtopic.php?tid=104671 

Printable Version  
[ Total Views: 947 | Total Replies: 7 | Thread Id: 97225 ]
Author: Subject:  [FS - NSW] 62 Beetle project SOLD!!
Memberkombi1976
Casual Dubber
*


Avatar


Posts: 37
Threads: 10
Registered: October 9th, 2007
Member Is Offline

Location: NSW Southern Tablelands
Theme: UltimaBB Streamlined2
Mood: Totally up for sambar

posted on June 3rd, 2012 at 03:00 AM
[FS - NSW] 62 Beetle project SOLD!!


I was working on this car in an attempt to have it ready for Valla but it has to go to fund another purchase.
It has an original 40hp stale air motor that runs well after a carb adjustment. Drops a little oil and has a bit of endplay but is a good unit.
Gearbox shifts well and clutch is fine.
Converted to dual master and has new wheel cylinders and shoes all around. Some fine tuning needed but all plumbed in.
Still 6 volt and needs new battery. Lights and indicators also need sorting but it's little stuff.
Rust in drivers side front wheel arch and A-pillar. A couple of other places will need attention eventually but so far they are ok. Door bottoms are fine and pan is spotless.
Original paint is gone on most of the car although it's still there under a coat of black house paint in the interior.
The roof trim is pretty bad but it can be tidied up. New window seals are also needed.
With the car comes the original seats which probably need new covers but are mostly ok. There are also a full set of original door cards from another Beetle, the rear and passenger side are brick red and the driver side is slightly darker red, although it may just need a really good clean. These are in excellent shape.
Car will come with some factory wide 14" rims and a set of standard 15" skinny rims. There's also a replacement passenger side running board and some other bits.
If you are good with a spanner and can weld just a little this car will be road ready in a weekend and it makes the perfect basis for a rat. It goes, it stops, it's only peripherals keeping it from a blueslip.
If you'd like to inspect it it's currently at the Volksmuller workshop in Annangrove but it needs to go pronto. I don't have a postcode for Annangrove but it's Rouse Hill, Dural area in Sydney.

SOLD!!

http://i253.photobucket.com/albums/hh79/kombi76/61%20Beetle/62Beetle_030.jpg

http://i253.photobucket.com/albums/hh79/kombi76/61%20Beetle/62Beetle_032.jpg

http://i253.photobucket.com/albums/hh79/kombi76/61%20Beetle/62Beetle_033.jpg

http://i253.photobucket.com/albums/hh79/kombi76/61%20Beetle/62Beetle_030.jpg

The door cards:
http://i253.photobucket.com/albums/hh79/kombi76/61%20Beetle/62Beetle_2ndHandDoorTrims_01.jpg




Cheers & God Bless
'62 Beetle ~ '62 Panel project ~ '67 Panelhttp://www.dsk.com.au
http://i253.photobucket.com/albums/hh79/kombi76/RatDay2011_001edit.jpg

MemberDubLeg
A.k.a.: Lewis Templar
Officially Full-On Dubber
***


Avatar


Posts: 208
Threads: 46
Registered: June 20th, 2011
Member Is Offline

Location: Wishart, QLD
Theme: UltimaBB Psyche Red

posted on June 3rd, 2012 at 08:42 AM



How much work would need to be done to get this driven back to QLD?

I want to have it, but location is a problem. It will be too expensive to pick up or freight. I would drive it back, with day rego




VollyWaffle
Memberroad_zombie
Casual Dubber
*


Avatar


Posts: 42
Threads: 7
Registered: June 8th, 2010
Member Is Offline

Location: Buffalo River
Theme: UltimaBB Pro Grey

posted on June 3rd, 2012 at 09:43 PM



think you need a rwc to get a permit in NSW and the qld is of no use as the car is in NSW



if it aint rusty it aint mine
Memberkombi1976
Casual Dubber
*


Avatar


Posts: 37
Threads: 10
Registered: October 9th, 2007
Member Is Offline

Location: NSW Southern Tablelands
Theme: UltimaBB Streamlined2
Mood: Totally up for sambar

posted on June 4th, 2012 at 12:20 AM



We don't have RWCs in NSW, we have blue slips.
I reckon if the QLD registry are happy to grant the day rego and the car looks safe and not like a wheel will fall off or it'll leap off the road any second the police will leave it alone.
Drive it like you stole it and have it wobbling all over the place, well, serves you right, doesn't it?




Cheers & God Bless
'62 Beetle ~ '62 Panel project ~ '67 Panelhttp://www.dsk.com.au
http://i253.photobucket.com/albums/hh79/kombi76/RatDay2011_001edit.jpg

Memberroad_zombie
Casual Dubber
*


Avatar


Posts: 42
Threads: 7
Registered: June 8th, 2010
Member Is Offline

Location: Buffalo River
Theme: UltimaBB Pro Grey

posted on June 4th, 2012 at 06:03 PM



whats a pink slip then only need a blue slip if its been out of reg for more than 3 months or the vehicle comes from out of state



if it aint rusty it aint mine
Memberkombi1976
Casual Dubber
*


Avatar


Posts: 37
Threads: 10
Registered: October 9th, 2007
Member Is Offline

Location: NSW Southern Tablelands
Theme: UltimaBB Streamlined2
Mood: Totally up for sambar

posted on June 4th, 2012 at 06:07 PM



Quote:
Originally posted by road_zombie
whats a pink slip then only need a blue slip if its been out of reg for more than 3 months or the vehicle comes from out of state

Yep, but since this hasn't had rego for 20+ years I think it might JUST be out of pink slip territory....... ;)




Cheers & God Bless
'62 Beetle ~ '62 Panel project ~ '67 Panelhttp://www.dsk.com.au
http://i253.photobucket.com/albums/hh79/kombi76/RatDay2011_001edit.jpg

MemberGottaSplit
A.k.a.: Jamie
Seriously Crusin Dubber
**


Avatar


Posts: 101
Threads: 8
Registered: November 20th, 2010
Member Is Offline

Location: Northern Beaches Sydney
Theme: UltimaBB Psyche Blue

posted on June 5th, 2012 at 05:14 PM



Pleasure doing business with you Andy.. A little bit of work involved but she will look fantastic as a lowered rat. Keep all posted on the build... :)



1960 11 Window
Memberkombi1976
Casual Dubber
*


Avatar


Posts: 37
Threads: 10
Registered: October 9th, 2007
Member Is Offline

Location: NSW Southern Tablelands
Theme: UltimaBB Streamlined2
Mood: Totally up for sambar

posted on June 5th, 2012 at 05:53 PM



Quote:
Originally posted by GottaSplit
Pleasure doing business with you Andy.. A little bit of work involved but she will look fantastic as a lowered rat. Keep all posted on the build... :)

Likewise, mate.
It's nice to know it's going to a good home where it will be finished and loved.
Looking forward to the build and the finished product.




Cheers & God Bless
'62 Beetle ~ '62 Panel project ~ '67 Panelhttp://www.dsk.com.au
http://i253.photobucket.com/albums/hh79/kombi76/RatDay2011_001edit.jpg



  Go To Top


Powered by GaiaBB, © 2011 The GaiaBB Group
(C) 2001-2024 Aussieveedubbers

[ Queries: 40 ] [ PHP: 3.5% - SQL: 96.5% ]