Board Logo
Go To Bottom

Printable Version  
[ Total Views: 885 | Total Replies: 8 | Thread Id: 32832 ]
Author: Subject: using electric fuel pump in place of mechanical pump
Member68notch
Casual Dubber
*


No Avatar


Posts: 32
Threads: 6
Registered: May 20th, 2003
Member Is Offline

Location: Dural, NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: bah!

posted on December 11th, 2004 at 07:35 PM
using electric fuel pump in place of mechanical pump


Hi guys,
I have a suspect stock fuel pump in my Notchback that I want to replace with an electric one.
On the shelf I have a mazda electric fuel pump that I know works. Can I just wire it up and connect it in place of the stock mechanical pump or do I need to resort to extreme measures to use it?
I am running twin solexes and I have a blockoff plate already to plug the hole in the case so just wondering does this pump require a return line and/or regulator? Will the needle and seat in the carbs regulate fuel pressure and flow?
I have no idea so help is greatly appreciated regarding making the switch!
Regards,
JT
Member68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
**********


Avatar


Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline

Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -

posted on December 11th, 2004 at 09:45 PM


Hi JT....

The best place to put the electric fuel pump is under the fuel tank... and just wire it to the ignition circuit... if You add a switch somewhere.. it doubles as an anti-steal switch....
The pressure from electric pumps into the carburetors can be too high for the needle & seat.... so You will probably need a fuel pressure regulator....
I did with Mine.... the engine flooded, so I switched the pump off for a few seconds and the engine came good..... I have now fitted a Holley adjustable fuel pressure regulator... in the engine compartment before the fuel goes to the carby..

See how You go...

Just take everything out of the old fuel pump hole....
and block it off with a plate + gasket or silastic....

My Son runs an electric pump in the engine bay in His Baja....
and a holley fuel pressure adjuster with Holley Bugspray carby.... Your Mazda pump may be regulated already??

Lee




- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
MemberOasis
Custom Title Time!
Going alone...
*****


Avatar


Posts: 1806
Threads: 77
Registered: July 5th, 2003
Member Is Offline

Location: Cammeray, Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: Deep

posted on December 12th, 2004 at 01:40 AM


Only use a Malpassy fuel pressure regulator. Different carbies like different amounts of pressure. Read http://www.lowbugget.com  for Kadrons. Only what I've read and been told...



"Tell him 'We've already got one'"
MemberBiX
Veteran Volks Folk
*****


Avatar


Posts: 2499
Threads: 154
Registered: September 2nd, 2002
Member Is Offline

Location: Brisbane
Theme: UltimaBB Pro Blue ( Default )

posted on December 14th, 2004 at 08:22 AM


is the mazda pump a from a fuel injected engine or a carby engine?



I have no sympathy for my car, only the wallet that pays for it!
Go hard or go home!!!!
Member68notch
Casual Dubber
*


No Avatar


Posts: 32
Threads: 6
Registered: May 20th, 2003
Member Is Offline

Location: Dural, NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: bah!

posted on December 14th, 2004 at 02:36 PM


Thanks for all your help guys.
The mazda pump is from a 929 carby model. Unfortunately it had seized after sitting for a couple of years and no amount of dismantling and cleaning out the crud could make it operate reliably so I'm back to square one. :jesus
After reading another post by dannyboy67 it looks like he's got it sorted so at least now I know what I'm up for and pretty much how and where to fit one.

I'll post in the tech talk section a question regarding the problem that lead me to wanting to go electric in the first place.

Thanks again!
JT
Member68notch
Casual Dubber
*


No Avatar


Posts: 32
Threads: 6
Registered: May 20th, 2003
Member Is Offline

Location: Dural, NSW
Theme: UltimaBB Pro Blue ( Default )
Mood: bah!

posted on December 15th, 2004 at 06:04 PM


Hey 68Auto, how did you regulate the fuel pressure?
I mean did you have to use a pressure gauge (like a T connection one) and just dial up the correct pressure on the regulator?
Also, what did you pay for your Holley one? I'm just after an idea of what the expense will be if you don't mind mentioning it ;)
MemberCraig Paton
Wolfsburg Wizard
***


Avatar


Posts: 620
Threads: 68
Registered: April 2nd, 2004
Member Is Offline

Location: Toowoomba QLD
Theme: UltimaBB Pro Blue ( Default )
Mood: Absolutely Gratefull..!

posted on December 15th, 2004 at 08:08 PM


I have a Jaguar 6 cyl fuel pump that is self regulating and is quiet! I think it is a S.U. pump!

I believe these are sold from a business in Syd. Probably could contact some Pommy car clubs to find out more.

Cheers
Member68AutoBug
A.k.a.: Lee Noonan
Aircooled Master
Beetle Restorer - Experience over 138% - YIKES --
**********


Avatar


Posts: 11654
Threads: 449
Registered: August 31st, 2002
Member Is Offline

Location: SCONE in UPPER HUNTER VALLEY NSW
Theme: UltimaBB Pro Yellow
Mood: Really Mentally Ill - all of the time -

posted on December 19th, 2004 at 11:34 PM


Yes the Holley regulator I bought off ebay cost $70 and is adjusted with a screw driver...
It came with no details of how to adjust...
ie,, which way to turn the adjusting screw....

My Son bought a holley adjuster with a large metal knob on the top... looks better and is easy to adjust...
It is just in the fuel line before the carburetor...
Mine is mounted on the fan housing...
cost about the same I think... two years ago..

Lee




- [size=4]Helping keep Air Cooled VWs on the road - location: SCONE in the Upper Hunter Valley - Northern NSW 320 kms NNW of SYDNEY--- [/size]
Membermatara
Custom Title Time!
*****


Avatar


Posts: 1342
Threads: 255
Registered: August 25th, 2002
Member Is Offline

Location: Melrose Park, Sydney
Theme: UltimaBB Pro Grey
Mood: 356'd

posted on December 20th, 2004 at 08:42 AM


What are the benefits of an electric pump over a stock pump in an otherwise stock motor?

Thanks

Steve




http://www.matara.net/vwpics/myvws/sigpicx600.jpg


  Go To Top


Powered by GaiaBB, © 2011 The GaiaBB Group
(C) 2001-2025 Aussieveedubbers

[ Queries: 40 ] [ PHP: 12.9% - SQL: 87.1% ]