Board Logo
Go To Bottom

Printable Version  
[ Total Views: 498 | Total Replies: 3 | Thread Id: 49705 ]
Author: Subject:  question re. manifold studs
Memberoldnslo
Seriously Crusin Dubber
**


No Avatar


Posts: 162
Threads: 50
Registered: February 22nd, 2005
Member Is Offline

Location: adelaide
Theme: UltimaBB Pro Blue ( Default )

posted on March 10th, 2006 at 07:46 PM
question re. manifold studs


Im having trouble getting new inlet manifold studs for my 36 hp engine {6mm i think]. Can I just use 6mm bolts instead? Any ideas folks?
Membernbturbo
Veteran Volks Folk
*****


Avatar


Posts: 2171
Threads: 89
Registered: December 19th, 2002
Member Is Offline

Location: Whyalla Sth.Aust.
Theme: UltimaBB Powder

posted on March 10th, 2006 at 08:21 PM



Yes-or get some set screws which are all thread-and cut them to length,clean up the thread and screw them in using 2 nuts.
Memberoldnslo
Seriously Crusin Dubber
**


No Avatar


Posts: 162
Threads: 50
Registered: February 22nd, 2005
Member Is Offline

Location: adelaide
Theme: UltimaBB Pro Blue ( Default )

posted on March 10th, 2006 at 08:35 PM



set screws, can you get them from motor traders?
Memberjnr356
Wolfsburg Wizard
***


Avatar


Posts: 603
Threads: 33
Registered: January 17th, 2004
Member Is Offline

Location: Ost melburg
Theme: UltimaBB Pro Blue ( Default )
Mood: casual

posted on March 10th, 2006 at 09:50 PM



6mm x 1.0mm thread



http://s23.postimg.org/vl55hvvev/flipinthebirdcopy3.jpg


  Go To Top


Powered by GaiaBB, © 2011 The GaiaBB Group
(C) 2001-2025 Aussieveedubbers

[ Queries: 40 ] [ PHP: 2.0% - SQL: 98.0% ]