Board Logo
Go To Bottom

Printable Version  
[ Total Views: 1007 | Total Replies: 7 | Thread Id: 57005 ]
Author: Subject:  ej20t check eng light
MemberKlaus
Custom Title Time!
*****


Avatar


Posts: 1439
Threads: 100
Registered: August 25th, 2004
Member Is Offline

Location: Wollongong
Theme: UltimaBB Pro Blue ( Default )
Mood: Heavily modified

posted on October 3rd, 2006 at 04:28 PM
ej20t check eng light


Got the ej20t in the back of my 68 square engineered and regoed . Went for a drive down the coast not a problem then check engine light comes on along with thermo fan. engine is not hot , as i slow down for set of lights the light goes off. This also happens when i give it a bit and a few seconds later light is on , pull over turn off then on again light is off. From what i've been reading the light should stay on if there is a fault . This could be faulty connector or air leak? just want to see if anyone else has had this problem . also engine is out of an auto and have seen that the water pump for manual and auto are diff part numbers should i change to manual water pump?
any help would be fantastic ohh engine also goes into limp mode with about a 4500 rev limit while light is on.
Membergull
Wolfsburg Wizard
***


No Avatar


Posts: 446
Threads: 34
Registered: June 30th, 2005
Member Is Offline

Theme: UltimaBB Pro Blue ( Default )

posted on October 3rd, 2006 at 04:53 PM



earth , run another
MemberKlaus
Custom Title Time!
*****


Avatar


Posts: 1439
Threads: 100
Registered: August 25th, 2004
Member Is Offline

Location: Wollongong
Theme: UltimaBB Pro Blue ( Default )
Mood: Heavily modified

posted on October 4th, 2006 at 03:35 PM



will do that , reconnected diag plugs turns out faults are 24 idle valve and 33 speed sensor , thinking if neutral wire should be earthed out or not , to simulate it not being in neutral?
Membermustard
Learner Dubber
*


No Avatar


Posts: 9
Threads: 0
Registered: June 4th, 2004
Member Is Offline

Location: Newcastle
Theme: UltimaBB Pro Blue ( Default )
Mood: closer than b4

posted on October 4th, 2006 at 07:56 PM



i had code 24 iac valve problems when first rego'd
bought a second hand one and it to was problematic

bought a can of carby cleaner and cleaned up the original
and it's now as good as gold.

the check engine light was doing the same as yours
would come on and off and show code 24 on the scanner.

don't know about the limp mode i thought it would go into limp
and you wouldn't be able to rev it anywhere near 4500
could it maybe be a plug, plug lead or coil????????????
MemberKlaus
Custom Title Time!
*****


Avatar


Posts: 1439
Threads: 100
Registered: August 25th, 2004
Member Is Offline

Location: Wollongong
Theme: UltimaBB Pro Blue ( Default )
Mood: Heavily modified

posted on October 9th, 2006 at 08:29 PM



ahhh solved that problem turns out speed sensor was not hooked up so modified subi speedo to fit in stock position and modded speedo cable to fit now all good until saturday had batt cable come off and cause havoc and now i'm getting a error 23 which is airflow meter just priced one for about 650.00 from dealer it never ends but its all worth it for the times it runs sweet.
Memberspeedster356
A.k.a.: Peter Mcleod
Custom Title Time!
Plastic not Classic Racing
*****


Avatar


Posts: 1624
Threads: 256
Registered: August 25th, 2002
Member Is Offline

Location: CHRIST church NZ
Theme: UltimaBB Pro Blue ( Default )
Mood: Producing boost again in NZ

posted on October 9th, 2006 at 09:10 PM



I've got a good AFM if you want one. $100 + shipping. Just mail me if your interested.



Spyder-WISD 07-09-05 11.6s @ 125 MPH

Speedster-WISD Nats 05 14.4s @ 89 MPH

Jet cruiser-Coogee 22-09-05 900 deg C @ 110,000 rpm

Weaseling out of things is what separates us from the animals....................Except the Weasel.
MemberKlaus
Custom Title Time!
*****


Avatar


Posts: 1439
Threads: 100
Registered: August 25th, 2004
Member Is Offline

Location: Wollongong
Theme: UltimaBB Pro Blue ( Default )
Mood: Heavily modified

posted on October 16th, 2006 at 10:14 AM



Bugger just picked one up for 300.
Membervwtyp2
Son of Jim - Creator of Good
******


Avatar


Posts: 2504
Threads: 160
Registered: September 18th, 2003
Member Is Offline

Location: Hillcrest S.A.
Theme: UltimaBB Pro Blue ( Default )
Mood: over it

posted on October 17th, 2006 at 09:49 AM



this may be useful to you.
helped me out.
http://www.legacycentral.org/library/literature/codes.htm 




Most people seem normal, till you get to know them.


  Go To Top


Powered by GaiaBB, © 2011 The GaiaBB Group
(C) 2001-2024 Aussieveedubbers

[ Queries: 40 ] [ PHP: 10.9% - SQL: 89.1% ]