Posts: 478
Threads: 82
Registered: March 1st, 2008
Member Is Offline
Location: Perth
Theme: UltimaBB Pro Grey
Mood: Born 10 minutes late & never caught up.
posted on September 28th, 2009 at 11:23 PM
Attaching pan halves
Hi Guys,
I am finally ready to replace the pan halves. I have trimmed to fit and am ready to weld in.
Any tips on fixing the pan halves in?
My present plan is to drill 3/16 holes in the panel periodically and then mig weld through the holes and build out to the pan (not that I have tried
this before - my forte is gas).
Cheers
Newt
It is as it is - If you didnt enjoy today, you've missed the opportunity.
vw54
Super Administrator
Always Waiting 4 Friday
Posts: 16723
Threads: 378
Registered: August 26th, 2002
Member Is Offline
Location: Sunny Sydney
Theme: UltimaBB Pro Blue ( Default )
Mood: Oval resto ongoing
posted on September 29th, 2009 at 07:01 AM
yep do some check measurements on both sides to see if there even
clamp and weld if you can get a extra long set of vice grips to reach the tunnel or get a mate with a long heavy rod to push down on the panels
to get good contact
