Skip to content
Aussieveedubbers

MY 64 still not finished aaaarrrgghhh

0 likes
Share Share on Facebook Share on X Share on Reddit

BASHOdi Wolfsburg Wizard

441 posts · joined Nov 2006 ·

#596666
Bought with a heap of stuff already done have re-done all the front suspension all replaced with new , brakes--all linings , cylinders , single master replaced with twin (today) -all replaced with new-- gearbox --replaced with 1500 ---Clutch replaced at the same time with new German as the high pressure one in the car was a PITA in traffic and gross overkill --reupholstered interior, new seats at the front, re-wired, replaced with marine and relocated fuse box so I could install ICE (ClarionDB566USB) Sony speakers no secondary amp or sub --quite honestly I dont need it--it already shakes thew windows loose as it is. Installed the origional radio which works independantly like on one speaker (Jensen) amazingly good sound , relocated the washer bottle to under the back seat tubed the rear speaker wire and the washerbottle electrics to run to the rear .Runnining a worked 1641 re-build (bought with car) with a Scat C35 cam 12.5lb flywheel , 38mm twin throat webber on custom s/s manifold re-worked case and a load of all new and worked engine bits.
And still aint near finished.
clik tO MAKE BIG






[ Edited on 3-8-2007 by BASHOdi ]

LUFTMEISTER Veteran Volks Folk

2,041 posts · joined Jul 2005 ·

#596785
looking good! will you be ready for the gold coast meet?
Customer service is not dead in Australia.

Always after HAZET & MATRA & VW factory tools

BASHOdi Wolfsburg Wizard

441 posts · joined Nov 2006 ·

#596868
DUBB61 wrote:looking good! will you be ready for the gold coast meet?
Yup but I might bring the wifes PT as I'm hoping to come across o set of towlys on the bring and buy and it'll be easier to bring em back in ---just had a thought--bring some tools and fit em there if I getem and sell my brazilian beautys cheep to save bringin them home Ha !🤖