Good evening AVD-ers,
I have a deck height of 4mm (0.157 inch), want to shave base of barrels to bring this down to 1.5mm (0.06inch) for squish/quench. Anyone a machinist here or can refer / recommend a machine shop in SE-QLD?
I don't want to swap rods. already been balanced & assembled. Same goes for pistons, already balanced. (94 x 74, alum case, 5.4 rods). Should'a got the 5.5 rods, i know i know!
Will then remove cc's from the heads by relieving around the bigger valves to balance comp rat. Currently with 4mm deck its at 7.6:1.
Thanks,
Chris.
bajachris88 The international telephone dialing code for Antarctica is 6
6,661 posts · joined Apr 2005 ·
(ô_!_/ô) (ô_!_/ô)
69' baja: kombi box, thing spindles, irs, disc front, type 3 rear drums, 2 inch lift kit, 31x10 rears. 👍
New engine in process: 94mm p&bs, 74mm C/w chomol Crank, 35.5x39 SP heads, turbo. Wierd combo, hopeful torque monsta!
69' baja: kombi box, thing spindles, irs, disc front, type 3 rear drums, 2 inch lift kit, 31x10 rears. 👍
New engine in process: 94mm p&bs, 74mm C/w chomol Crank, 35.5x39 SP heads, turbo. Wierd combo, hopeful torque monsta!
